blob: 9d4c41b00b34b524471b18c7c59d62a59e2d8b50 [file] [log] [blame]
Luca Ceresolifb6e1f12011-04-20 11:02:08 -04001/*
2 * (C) Copyright 2011 Comelit Group SpA
3 * Luca Ceresoli <luca.ceresoli@comelit.it>
4 *
5 * Based on board/ti/beagle/beagle.c:
6 * (C) Copyright 2004-2008
7 * Texas Instruments, <www.ti.com>
8 *
9 * Author :
10 * Sunil Kumar <sunilsaini05@gmail.com>
11 * Shashi Ranjan <shashiranjanmca05@gmail.com>
12 *
13 * Derived from Beagle Board and 3430 SDP code by
14 * Richard Woodruff <r-woodruff2@ti.com>
15 * Syed Mohammed Khasim <khasim@ti.com>
16 *
17 *
Wolfgang Denk1a459662013-07-08 09:37:19 +020018 * SPDX-License-Identifier: GPL-2.0+
Luca Ceresolifb6e1f12011-04-20 11:02:08 -040019 */
20#include <common.h>
21#include <netdev.h>
22#include <twl4030.h>
23#include <asm/io.h>
Tom Rinieaff60d2011-09-03 21:50:05 -040024#include <asm/arch/mmc_host_def.h>
Luca Ceresolifb6e1f12011-04-20 11:02:08 -040025#include <asm/arch/omap3-regs.h>
26#include <asm/arch/mux.h>
27#include <asm/arch/mem.h>
28#include <asm/arch/sys_proto.h>
Sanjeev Premi84c3b632011-09-08 10:51:01 -040029#include <asm/gpio.h>
Luca Ceresolifb6e1f12011-04-20 11:02:08 -040030#include <asm/mach-types.h>
31#include "dig297.h"
32
33DECLARE_GLOBAL_DATA_PTR;
34
35#ifdef CONFIG_CMD_NET
36static void setup_net_chip(void);
37
38#define NET_LAN9221_RESET_GPIO 12
39
40/* GPMC CS 5 connected to an SMSC LAN9220 ethernet controller */
41#define NET_LAN9220_GPMC_CONFIG1 (DEVICESIZE_16BIT)
42#define NET_LAN9220_GPMC_CONFIG2 (CSWROFFTIME(8) | \
43 CSRDOFFTIME(7) | \
44 ADVONTIME(1))
45#define NET_LAN9220_GPMC_CONFIG3 (ADVWROFFTIME(2) | \
46 ADVRDOFFTIME(2) | \
47 ADVONTIME(1))
48#define NET_LAN9220_GPMC_CONFIG4 (WEOFFTIME(8) | \
49 WEONTIME(1) | \
50 OEOFFTIME(7)| \
51 OEONTIME(1))
52#define NET_LAN9220_GPMC_CONFIG5 (PAGEBURSTACCESSTIME(0) | \
53 RDACCESSTIME(6) | \
54 WRCYCLETIME(0x1D) | \
55 RDCYCLETIME(0x1D))
56#define NET_LAN9220_GPMC_CONFIG6 ((1 << 31) | \
57 WRACCESSTIME(0x1D) | \
58 WRDATAONADMUXBUS(3))
59
60static const u32 gpmc_lan_config[] = {
61 NET_LAN9220_GPMC_CONFIG1,
62 NET_LAN9220_GPMC_CONFIG2,
63 NET_LAN9220_GPMC_CONFIG3,
64 NET_LAN9220_GPMC_CONFIG4,
65 NET_LAN9220_GPMC_CONFIG5,
66 NET_LAN9220_GPMC_CONFIG6,
67 /* CONFIG7: computed by enable_gpmc_cs_config() */
68};
69#endif /* CONFIG_CMD_NET */
70
71/*
72 * Routine: board_init
73 * Description: Early hardware init.
74 */
75int board_init(void)
76{
77 gpmc_init(); /* in SRAM or SDRAM, finish GPMC */
Luca Ceresolifb6e1f12011-04-20 11:02:08 -040078 /* boot param addr */
79 gd->bd->bi_boot_params = (OMAP34XX_SDRC_CS0 + 0x100);
80
81 return 0;
82}
83
84/*
85 * Routine: misc_init_r
86 * Description: Configure board specific parts
87 */
88int misc_init_r(void)
89{
90 struct gpio *gpio1_base = (struct gpio *)OMAP34XX_GPIO1_BASE;
91 struct gpio *gpio5_base = (struct gpio *)OMAP34XX_GPIO5_BASE;
92
93 twl4030_power_init();
94 twl4030_led_init(TWL4030_LED_LEDEN_LEDAON | TWL4030_LED_LEDEN_LEDBON);
95
96 /*
97 * GPIO list
98 * - 159 OUT (GPIO5+31): reset for remote camera interface connector.
99 * - 19 OUT (GPIO1+19): integrated speaker amplifier (1=on, 0=shdn).
100 * - 20 OUT (GPIO1+20): handset amplifier (1=on, 0=shdn).
101 */
102
103 /* Configure GPIOs to output */
104 writel(~(GPIO19 | GPIO20), &gpio1_base->oe);
105 writel(~(GPIO31), &gpio5_base->oe);
106
107 /* Set GPIO values */
108 writel((GPIO19 | GPIO20), &gpio1_base->setdataout);
109 writel(0, &gpio5_base->setdataout);
110
111#if defined(CONFIG_CMD_NET)
112 setup_net_chip();
113#endif
114
115 dieid_num_r();
116
117 return 0;
118}
119
120/*
121 * Routine: set_muxconf_regs
122 * Description: Setting up the configuration Mux registers specific to the
123 * hardware. Many pins need to be moved from protect to primary
124 * mode.
125 */
126void set_muxconf_regs(void)
127{
128 MUX_DIG297();
129}
130
Tom Rinieaff60d2011-09-03 21:50:05 -0400131#ifdef CONFIG_GENERIC_MMC
132int board_mmc_init(bd_t *bis)
133{
Nikita Kiryanove3913f52012-12-03 02:19:47 +0000134 return omap_mmc_init(0, 0, 0, -1, -1);
Tom Rinieaff60d2011-09-03 21:50:05 -0400135}
Paul Kocialkowskiaac54502014-11-08 20:55:47 +0100136
137void board_mmc_power_init(void)
138{
139 twl4030_power_mmc_init(0);
140}
Tom Rinieaff60d2011-09-03 21:50:05 -0400141#endif
142
Luca Ceresolifb6e1f12011-04-20 11:02:08 -0400143#ifdef CONFIG_CMD_NET
144/*
145 * Routine: setup_net_chip
146 * Description: Setting up the configuration GPMC registers specific to the
147 * Ethernet hardware.
148 */
149static void setup_net_chip(void)
150{
151 struct ctrl *ctrl_base = (struct ctrl *)OMAP34XX_CTRL_BASE;
152
153 /* Configure GPMC registers */
154 enable_gpmc_cs_config(gpmc_lan_config, &gpmc_cfg->cs[5],
155 CONFIG_SMC911X_BASE, GPMC_SIZE_16M);
156
157 /* Enable off mode for NWE in PADCONF_GPMC_NWE register */
158 writew(readw(&ctrl_base->gpmc_nwe) | 0x0E00, &ctrl_base->gpmc_nwe);
159 /* Enable off mode for NOE in PADCONF_GPMC_NADV_ALE register */
160 writew(readw(&ctrl_base->gpmc_noe) | 0x0E00, &ctrl_base->gpmc_noe);
161 /* Enable off mode for ALE in PADCONF_GPMC_NADV_ALE register */
162 writew(readw(&ctrl_base->gpmc_nadv_ale) | 0x0E00,
163 &ctrl_base->gpmc_nadv_ale);
164
165 /* Make GPIO 12 as output pin and send a magic pulse through it */
Sanjeev Premi84c3b632011-09-08 10:51:01 -0400166 if (!gpio_request(NET_LAN9221_RESET_GPIO, "")) {
167 gpio_direction_output(NET_LAN9221_RESET_GPIO, 0);
168 gpio_set_value(NET_LAN9221_RESET_GPIO, 1);
Luca Ceresolifb6e1f12011-04-20 11:02:08 -0400169 udelay(1);
Sanjeev Premi84c3b632011-09-08 10:51:01 -0400170 gpio_set_value(NET_LAN9221_RESET_GPIO, 0);
Luca Ceresolifb6e1f12011-04-20 11:02:08 -0400171 udelay(31000); /* Should be >= 30ms according to datasheet */
Sanjeev Premi84c3b632011-09-08 10:51:01 -0400172 gpio_set_value(NET_LAN9221_RESET_GPIO, 1);
Luca Ceresolifb6e1f12011-04-20 11:02:08 -0400173 }
174}
175#endif /* CONFIG_CMD_NET */
176
177int board_eth_init(bd_t *bis)
178{
179 int rc = 0;
180 rc = smc911x_initialize(0, CONFIG_SMC911X_BASE);
181 return rc;
182}