wdenk | c609719 | 2002-11-03 00:24:07 +0000 | [diff] [blame] | 1 | /* |
wdenk | 04a85b3 | 2004-04-15 18:22:41 +0000 | [diff] [blame] | 2 | * (C) Copyright 2000-2004 |
wdenk | c609719 | 2002-11-03 00:24:07 +0000 | [diff] [blame] | 3 | * Wolfgang Denk, DENX Software Engineering, wd@denx.de. |
| 4 | * |
Wolfgang Denk | 1a45966 | 2013-07-08 09:37:19 +0200 | [diff] [blame] | 5 | * SPDX-License-Identifier: GPL-2.0+ |
wdenk | c609719 | 2002-11-03 00:24:07 +0000 | [diff] [blame] | 6 | */ |
| 7 | |
| 8 | /* |
| 9 | * The purpose of this code is to signal the operational status of a |
| 10 | * target which usually boots over the network; while running in |
| 11 | * PCBoot, a status LED is blinking. As soon as a valid BOOTP reply |
| 12 | * message has been received, the LED is turned off. The Linux |
| 13 | * kernel, once it is running, will start blinking the LED again, |
| 14 | * with another frequency. |
| 15 | */ |
| 16 | |
| 17 | #ifndef _STATUS_LED_H_ |
| 18 | #define _STATUS_LED_H_ |
| 19 | |
| 20 | #ifdef CONFIG_STATUS_LED |
| 21 | |
| 22 | #define STATUS_LED_OFF 0 |
| 23 | #define STATUS_LED_BLINKING 1 |
| 24 | #define STATUS_LED_ON 2 |
| 25 | |
| 26 | void status_led_tick (unsigned long timestamp); |
| 27 | void status_led_set (int led, int state); |
| 28 | |
| 29 | /***** TQM8xxL ********************************************************/ |
Wolfgang Denk | 77efe35 | 2010-09-19 21:28:25 +0200 | [diff] [blame] | 30 | #if defined(CONFIG_TQM8xxL) |
wdenk | c609719 | 2002-11-03 00:24:07 +0000 | [diff] [blame] | 31 | # define STATUS_LED_PAR im_cpm.cp_pbpar |
| 32 | # define STATUS_LED_DIR im_cpm.cp_pbdir |
| 33 | # define STATUS_LED_ODR im_cpm.cp_pbodr |
| 34 | # define STATUS_LED_DAT im_cpm.cp_pbdat |
| 35 | |
| 36 | # define STATUS_LED_BIT 0x00000001 |
Jean-Christophe PLAGNIOL-VILLARD | 6d0f6bc | 2008-10-16 15:01:15 +0200 | [diff] [blame] | 37 | # define STATUS_LED_PERIOD (CONFIG_SYS_HZ / 2) |
wdenk | c609719 | 2002-11-03 00:24:07 +0000 | [diff] [blame] | 38 | # define STATUS_LED_STATE STATUS_LED_BLINKING |
| 39 | |
| 40 | # define STATUS_LED_ACTIVE 1 /* LED on for bit == 1 */ |
| 41 | |
| 42 | # define STATUS_LED_BOOT 0 /* LED 0 used for boot status */ |
| 43 | |
| 44 | /***** MVS v1 **********************************************************/ |
| 45 | #elif (defined(CONFIG_MVS) && CONFIG_MVS < 2) |
| 46 | # define STATUS_LED_PAR im_ioport.iop_pdpar |
| 47 | # define STATUS_LED_DIR im_ioport.iop_pddir |
| 48 | # undef STATUS_LED_ODR |
| 49 | # define STATUS_LED_DAT im_ioport.iop_pddat |
| 50 | |
| 51 | # define STATUS_LED_BIT 0x00000001 |
Jean-Christophe PLAGNIOL-VILLARD | 6d0f6bc | 2008-10-16 15:01:15 +0200 | [diff] [blame] | 52 | # define STATUS_LED_PERIOD (CONFIG_SYS_HZ / 2) |
wdenk | c609719 | 2002-11-03 00:24:07 +0000 | [diff] [blame] | 53 | # define STATUS_LED_STATE STATUS_LED_BLINKING |
| 54 | |
| 55 | # define STATUS_LED_ACTIVE 1 /* LED on for bit == 1 */ |
| 56 | |
| 57 | # define STATUS_LED_BOOT 0 /* LED 0 used for boot status */ |
| 58 | |
wdenk | c609719 | 2002-11-03 00:24:07 +0000 | [diff] [blame] | 59 | /***** Someone else defines these *************************************/ |
| 60 | #elif defined(STATUS_LED_PAR) |
| 61 | |
| 62 | /* |
| 63 | * ADVICE: Define in your board configuration file rather than |
| 64 | * filling this file up with lots of custom board stuff. |
| 65 | */ |
| 66 | |
wdenk | 0db5bca | 2003-03-31 17:27:09 +0000 | [diff] [blame] | 67 | /***** CMI ********************************************************/ |
| 68 | #elif defined(CONFIG_CMI) |
wdenk | 8bde7f7 | 2003-06-27 21:31:46 +0000 | [diff] [blame] | 69 | # define STATUS_LED_DIR im_mios.mios_mpiosm32ddr |
| 70 | # define STATUS_LED_DAT im_mios.mios_mpiosm32dr |
wdenk | 0db5bca | 2003-03-31 17:27:09 +0000 | [diff] [blame] | 71 | |
| 72 | # define STATUS_LED_BIT 0x2000 /* Select one of the 16 possible*/ |
| 73 | /* MIOS outputs */ |
Jean-Christophe PLAGNIOL-VILLARD | 6d0f6bc | 2008-10-16 15:01:15 +0200 | [diff] [blame] | 74 | # define STATUS_LED_PERIOD (CONFIG_SYS_HZ / 2) /* Blinking periode is 500 ms */ |
wdenk | 0db5bca | 2003-03-31 17:27:09 +0000 | [diff] [blame] | 75 | # define STATUS_LED_STATE STATUS_LED_BLINKING |
| 76 | |
| 77 | # define STATUS_LED_ACTIVE 1 /* LED on for bit == 0 */ |
| 78 | # define STATUS_LED_BOOT 0 /* LED 0 used for boot status */ |
| 79 | |
Bartlomiej Sieka | 4707fb5 | 2006-10-13 21:09:09 +0200 | [diff] [blame] | 80 | #elif defined(CONFIG_V38B) |
| 81 | |
| 82 | # define STATUS_LED_BIT 0x0010 /* Timer7 GPIO */ |
Jean-Christophe PLAGNIOL-VILLARD | 6d0f6bc | 2008-10-16 15:01:15 +0200 | [diff] [blame] | 83 | # define STATUS_LED_PERIOD (CONFIG_SYS_HZ / 2) |
Bartlomiej Sieka | 4707fb5 | 2006-10-13 21:09:09 +0200 | [diff] [blame] | 84 | # define STATUS_LED_STATE STATUS_LED_BLINKING |
| 85 | |
| 86 | # define STATUS_LED_ACTIVE 0 /* LED on for bit == 0 */ |
| 87 | # define STATUS_LED_BOOT 0 /* LED 0 used for boot status */ |
| 88 | |
Bartlomiej Sieka | a11c0b8 | 2007-05-27 16:51:48 +0200 | [diff] [blame] | 89 | #elif defined(CONFIG_MOTIONPRO) |
| 90 | |
| 91 | #define STATUS_LED_BIT ((vu_long *) MPC5XXX_GPT6_ENABLE) |
Jean-Christophe PLAGNIOL-VILLARD | 6d0f6bc | 2008-10-16 15:01:15 +0200 | [diff] [blame] | 92 | #define STATUS_LED_PERIOD (CONFIG_SYS_HZ / 10) |
Bartlomiej Sieka | a11c0b8 | 2007-05-27 16:51:48 +0200 | [diff] [blame] | 93 | #define STATUS_LED_STATE STATUS_LED_BLINKING |
| 94 | |
| 95 | #define STATUS_LED_BIT1 ((vu_long *) MPC5XXX_GPT7_ENABLE) |
Jean-Christophe PLAGNIOL-VILLARD | 6d0f6bc | 2008-10-16 15:01:15 +0200 | [diff] [blame] | 96 | #define STATUS_LED_PERIOD1 (CONFIG_SYS_HZ / 10) |
Bartlomiej Sieka | a11c0b8 | 2007-05-27 16:51:48 +0200 | [diff] [blame] | 97 | #define STATUS_LED_STATE1 STATUS_LED_OFF |
| 98 | |
| 99 | #define STATUS_LED_BOOT 0 /* LED 0 used for boot status */ |
| 100 | |
Heiko Schocher | 566a494 | 2007-06-22 19:11:54 +0200 | [diff] [blame] | 101 | #elif defined(CONFIG_BOARD_SPECIFIC_LED) |
| 102 | /* led_id_t is unsigned long mask */ |
| 103 | typedef unsigned long led_id_t; |
| 104 | |
| 105 | extern void __led_toggle (led_id_t mask); |
| 106 | extern void __led_init (led_id_t mask, int state); |
| 107 | extern void __led_set (led_id_t mask, int state); |
wdenk | c609719 | 2002-11-03 00:24:07 +0000 | [diff] [blame] | 108 | #else |
| 109 | # error Status LED configuration missing |
| 110 | #endif |
| 111 | /************************************************************************/ |
| 112 | |
wdenk | 48b4261 | 2003-06-19 23:01:32 +0000 | [diff] [blame] | 113 | #ifndef CONFIG_BOARD_SPECIFIC_LED |
| 114 | # include <asm/status_led.h> |
| 115 | #endif |
| 116 | |
Jeroen Hofstee | c5d4001 | 2014-06-23 23:20:19 +0200 | [diff] [blame] | 117 | #endif /* CONFIG_STATUS_LED */ |
| 118 | |
Wolfgang Denk | de74b9e | 2007-10-13 21:15:39 +0200 | [diff] [blame] | 119 | /* |
Peter Pearse | bd86220 | 2007-09-18 13:07:54 +0100 | [diff] [blame] | 120 | * Coloured LEDs API |
Wolfgang Denk | de74b9e | 2007-10-13 21:15:39 +0200 | [diff] [blame] | 121 | */ |
Peter Pearse | bd86220 | 2007-09-18 13:07:54 +0100 | [diff] [blame] | 122 | #ifndef __ASSEMBLY__ |
Jeroen Hofstee | c5d4001 | 2014-06-23 23:20:19 +0200 | [diff] [blame] | 123 | void coloured_LED_init(void); |
| 124 | void red_led_on(void); |
| 125 | void red_led_off(void); |
| 126 | void green_led_on(void); |
| 127 | void green_led_off(void); |
| 128 | void yellow_led_on(void); |
| 129 | void yellow_led_off(void); |
| 130 | void blue_led_on(void); |
| 131 | void blue_led_off(void); |
Peter Pearse | bd86220 | 2007-09-18 13:07:54 +0100 | [diff] [blame] | 132 | #else |
| 133 | .extern LED_init |
Jason Kridner | 2d3be7c | 2011-09-04 14:40:16 -0400 | [diff] [blame] | 134 | .extern red_led_on |
| 135 | .extern red_led_off |
| 136 | .extern yellow_led_on |
| 137 | .extern yellow_led_off |
| 138 | .extern green_led_on |
| 139 | .extern green_led_off |
| 140 | .extern blue_led_on |
| 141 | .extern blue_led_off |
Peter Pearse | bd86220 | 2007-09-18 13:07:54 +0100 | [diff] [blame] | 142 | #endif |
| 143 | |
wdenk | c609719 | 2002-11-03 00:24:07 +0000 | [diff] [blame] | 144 | #endif /* _STATUS_LED_H_ */ |