Chunhe Lan | 5707233 | 2013-06-14 16:21:48 +0800 | [diff] [blame] | 1 | /* |
| 2 | * Copyright 2013 Freescale Semiconductor, Inc. |
| 3 | * |
| 4 | * Authors: Roy Zang <tie-fei.zang@freescale.com> |
| 5 | * Chunhe Lan <Chunhe.Lan@freescale.com> |
| 6 | * |
Wolfgang Denk | 1a45966 | 2013-07-08 09:37:19 +0200 | [diff] [blame] | 7 | * SPDX-License-Identifier: GPL-2.0+ |
Chunhe Lan | 5707233 | 2013-06-14 16:21:48 +0800 | [diff] [blame] | 8 | */ |
| 9 | |
| 10 | #include <common.h> |
| 11 | #include <command.h> |
| 12 | #include <pci.h> |
| 13 | #include <asm/io.h> |
| 14 | #include <asm/cache.h> |
| 15 | #include <asm/processor.h> |
| 16 | #include <asm/mmu.h> |
| 17 | #include <asm/immap_85xx.h> |
| 18 | #include <asm/fsl_pci.h> |
York Sun | 5614e71 | 2013-09-30 09:22:09 -0700 | [diff] [blame] | 19 | #include <fsl_ddr_sdram.h> |
Chunhe Lan | 5707233 | 2013-06-14 16:21:48 +0800 | [diff] [blame] | 20 | #include <asm/fsl_portals.h> |
| 21 | #include <libfdt.h> |
| 22 | #include <fdt_support.h> |
| 23 | #include <netdev.h> |
| 24 | #include <malloc.h> |
| 25 | #include <fm_eth.h> |
| 26 | #include <fsl_mdio.h> |
| 27 | #include <miiphy.h> |
| 28 | #include <phy.h> |
| 29 | #include <asm/fsl_dtsec.h> |
| 30 | |
| 31 | DECLARE_GLOBAL_DATA_PTR; |
| 32 | |
| 33 | int board_early_init_f(void) |
| 34 | { |
| 35 | fsl_lbc_t *lbc = LBC_BASE_ADDR; |
| 36 | |
| 37 | /* Set ABSWP to implement conversion of addresses in the LBC */ |
| 38 | setbits_be32(&lbc->lbcr, CONFIG_SYS_LBC_LBCR); |
| 39 | |
| 40 | return 0; |
| 41 | } |
| 42 | |
| 43 | int checkboard(void) |
| 44 | { |
| 45 | printf("Board: P1023 RDB\n"); |
| 46 | |
| 47 | return 0; |
| 48 | } |
| 49 | |
| 50 | #ifdef CONFIG_PCI |
| 51 | void pci_init_board(void) |
| 52 | { |
| 53 | fsl_pcie_init_board(0); |
| 54 | } |
| 55 | #endif |
| 56 | |
| 57 | int board_early_init_r(void) |
| 58 | { |
| 59 | const unsigned int flashbase = CONFIG_SYS_FLASH_BASE; |
| 60 | const u8 flash_esel = find_tlb_idx((void *)flashbase, 1); |
| 61 | |
| 62 | /* |
| 63 | * Remap Boot flash + PROMJET region to caching-inhibited |
| 64 | * so that flash can be erased properly. |
| 65 | */ |
| 66 | |
| 67 | /* Flush d-cache and invalidate i-cache of any FLASH data */ |
| 68 | flush_dcache(); |
| 69 | invalidate_icache(); |
| 70 | |
| 71 | /* invalidate existing TLB entry for flash + promjet */ |
| 72 | disable_tlb(flash_esel); |
| 73 | |
| 74 | set_tlb(1, flashbase, CONFIG_SYS_FLASH_BASE_PHYS, |
| 75 | MAS3_SW|MAS3_SR, MAS2_I|MAS2_G, |
| 76 | 0, flash_esel, BOOKE_PAGESZ_256M, 1); |
| 77 | |
| 78 | setup_portals(); |
| 79 | |
| 80 | return 0; |
| 81 | } |
| 82 | |
| 83 | unsigned long get_board_sys_clk(ulong dummy) |
| 84 | { |
| 85 | return gd->bus_clk; |
| 86 | } |
| 87 | |
| 88 | unsigned long get_board_ddr_clk(ulong dummy) |
| 89 | { |
| 90 | return gd->mem_clk; |
| 91 | } |
| 92 | |
| 93 | int board_eth_init(bd_t *bis) |
| 94 | { |
| 95 | ccsr_gur_t *gur = (ccsr_gur_t *)CONFIG_SYS_MPC85xx_GUTS_ADDR; |
| 96 | struct fsl_pq_mdio_info dtsec_mdio_info; |
| 97 | |
| 98 | /* |
| 99 | * Need to set dTSEC 1 pin multiplexing to TSEC. The default setting |
| 100 | * is not correct. |
| 101 | */ |
| 102 | setbits_be32(&gur->pmuxcr, MPC85xx_PMUXCR_TSEC1_1); |
| 103 | |
| 104 | dtsec_mdio_info.regs = |
| 105 | (struct tsec_mii_mng *)CONFIG_SYS_FM1_DTSEC1_MDIO_ADDR; |
| 106 | dtsec_mdio_info.name = DEFAULT_FM_MDIO_NAME; |
| 107 | |
| 108 | /* Register the 1G MDIO bus */ |
| 109 | fsl_pq_mdio_init(bis, &dtsec_mdio_info); |
| 110 | |
| 111 | fm_info_set_phy_address(FM1_DTSEC1, CONFIG_SYS_FM1_DTSEC1_PHY_ADDR); |
| 112 | fm_info_set_phy_address(FM1_DTSEC2, CONFIG_SYS_FM1_DTSEC2_PHY_ADDR); |
| 113 | |
| 114 | fm_info_set_mdio(FM1_DTSEC1, |
| 115 | miiphy_get_dev_by_name(DEFAULT_FM_MDIO_NAME)); |
| 116 | fm_info_set_mdio(FM1_DTSEC2, |
| 117 | miiphy_get_dev_by_name(DEFAULT_FM_MDIO_NAME)); |
| 118 | |
| 119 | #ifdef CONFIG_FMAN_ENET |
| 120 | cpu_eth_init(bis); |
| 121 | #endif |
| 122 | |
| 123 | return pci_eth_init(bis); |
| 124 | } |
| 125 | |
| 126 | #if defined(CONFIG_OF_BOARD_SETUP) |
| 127 | void ft_board_setup(void *blob, bd_t *bd) |
| 128 | { |
| 129 | phys_addr_t base; |
| 130 | phys_size_t size; |
| 131 | |
| 132 | ft_cpu_setup(blob, bd); |
| 133 | |
| 134 | base = getenv_bootm_low(); |
| 135 | size = getenv_bootm_size(); |
| 136 | |
| 137 | fdt_fixup_memory(blob, (u64)base, (u64)size); |
| 138 | |
| 139 | #ifdef CONFIG_HAS_FSL_DR_USB |
| 140 | fdt_fixup_dr_usb(blob, bd); |
| 141 | #endif |
| 142 | |
| 143 | fdt_fixup_fman_ethernet(blob); |
| 144 | } |
| 145 | #endif |