| Fabio Estevam | 0768a69 | 2015-04-27 09:20:53 -0300 | [diff] [blame^] | 1 | How to use U-boot on Solid-run mx6 Hummingboard and Cubox-i |
| 2 | ----------------------------------------------------------- |
| Fabio Estevam | b8ce6fe | 2015-04-20 14:48:57 -0300 | [diff] [blame] | 3 | |
| Fabio Estevam | 0768a69 | 2015-04-27 09:20:53 -0300 | [diff] [blame^] | 4 | - Build U-boot for Hummingboard/Cubox-i: |
| Fabio Estevam | b8ce6fe | 2015-04-20 14:48:57 -0300 | [diff] [blame] | 5 | |
| 6 | $ make mrproper |
| 7 | $ make mx6cuboxi_defconfig |
| 8 | $ make |
| 9 | |
| 10 | This will generate the SPL image called SPL and the u-boot.img. |
| 11 | |
| 12 | - Flash the SPL image into the SD card: |
| 13 | |
| 14 | sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync |
| 15 | |
| 16 | - Flash the u-boot.img image into the SD card: |
| 17 | |
| 18 | sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync |
| 19 | |
| Fabio Estevam | 0768a69 | 2015-04-27 09:20:53 -0300 | [diff] [blame^] | 20 | - Insert the SD card in the board, power it up and U-boot messages should |
| 21 | come up. |