blob: cae14e055f85abe3da0840d522772221dabb457c [file] [log] [blame]
========================================
Renesas R0P7757LC0030RL board
========================================
This board specification:
=========================
The R0P7757LC0030RL(board config name:sh7757lcr) has the following device:
- SH7757 (SH-4A)
- DDR3-SDRAM 256MB (with ECC)
- SPI ROM 8MB
- 2D Graphic controller
- Ethernet controller
configuration for This board:
=============================
You can select the configuration as follows:
- make sh7785lcr_config
This board specific command:
============================
This board has the following its specific command:
- sh_g200
- write_mac
1. sh_g200
If we run this command, SH4 can control the G200.
The default setting is that SH4 cannot control the G200.
2. write_mac
You can write MAC address to SPI ROM.
Usage 1) Write MAC address
write_mac [ETHERC ch0] [ETHERC ch1] [GETHERC ch0] [GETHERC ch1]
For example)
=> write_mac 00:00:87:6c:21:80 00:00:87:6c:21:81 00:00:87:6c:21:82 00:00:87:6c:21:83
*) We have to input the command as a single line
(without carriage return)
*) We have to reset after input the command.
Usage 2) Show current data
write_mac
For example)
=> write_mac
ETHERC ch0 = 00:00:87:6c:21:80
ETHERC ch1 = 00:00:87:6c:21:81
GETHERC ch0 = 00:00:87:6c:21:82
GETHERC ch1 = 00:00:87:6c:21:83