blob: 28639c00414ccf0d495798f82149b70d64d15ab0 [file] [log] [blame]
if ROCKCHIP_PX30
config TARGET_EVB_PX30
bool "EVB_PX30"
help
This target config option used for below listed px30 boards.
EVB_PX30:
* EVB_PX30 is an evaluation board for Rockchip PX30.
config TARGET_ODROID_GO2
bool "ODROID_GO2"
config TARGET_PX30_CORE
bool "Engicam PX30.Core"
help
PX30.Core EDIMM2.2:
* PX30.Core is an EDIMM SOM based on Rockchip PX30 from Engicam.
* EDIMM2.2 is a Form Factor Capacitive Evaluation Board from Engicam.
* PX30.Core needs to mount on top of EDIMM2.2 for creating complete
PX30.Core EDIMM2.2 Starter Kit.
PX30.Core CTOUCH2:
* PX30.Core is an EDIMM SOM based on Rockchip PX30 from Engicam.
* CTOUCH2.0 is a general purpose Carrier board with capacitive
touch interface support.
* PX30.Core needs to mount on top of CTOUCH2.0 for creating complete
PX30.Core C.TOUCH Carrier board.
PX30.Core CTOUCH2-OF10:
* PX30.Core is an EDIMM SOM based on Rockchip PX30 from Engicam.
* CTOUCH2.0 is a general purpose Carrier board with capacitive
touch interface support.
* 10.1" OF is a capacitive touch 10.1" Open Frame panel solutions.
* PX30.Core needs to mount on top of C.TOUCH 2.0 carrier with pluged
10.1" OF for creating complete PX30.Core C.TOUCH 2.0 10.1" Open Frame.
config ROCKCHIP_BOOT_MODE_REG
default 0xff010200
config ROCKCHIP_STIMER_BASE
default 0xff220020
config SYS_SOC
default "px30"
config SYS_MALLOC_F_LEN
default 0x400
config SPL_SERIAL
default y
config TPL_LDSCRIPT
default "arch/arm/mach-rockchip/u-boot-tpl-v8.lds"
config TPL_TEXT_BASE
default 0xff0e1000
config TPL_STACK
default 0xff0e4fff
config DEBUG_UART_CHANNEL
int "Mux channel to use for debug UART2/UART3"
depends on DEBUG_UART_BOARD_INIT
default 0
help
UART2 and UART3 can use two different set of pins to route the output.
For using the UART for early debugging the route to use needs
to be declared (0 or 1).
source "board/engicam/px30_core/Kconfig"
source "board/hardkernel/odroid_go2/Kconfig"
source "board/rockchip/evb_px30/Kconfig"
endif