| /* |
| * Copyright (C) 2014 Marek Vasut <marex@denx.de> |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| #ifndef __CONFIG_SOCFPGA_CYCLONE5_H__ |
| #define __CONFIG_SOCFPGA_CYCLONE5_H__ |
| |
| #include <asm/arch/socfpga_base_addrs.h> |
| #include "../../board/altera/socfpga/pinmux_config.h" |
| #include "../../board/altera/socfpga/iocsr_config.h" |
| #include "../../board/altera/socfpga/pll_config.h" |
| |
| /* U-Boot Commands */ |
| #define CONFIG_SYS_NO_FLASH |
| #include <config_cmd_default.h> |
| #define CONFIG_DOS_PARTITION |
| #define CONFIG_FAT_WRITE |
| #define CONFIG_HW_WATCHDOG |
| |
| #define CONFIG_CMD_ASKENV |
| #define CONFIG_CMD_BOOTZ |
| #define CONFIG_CMD_CACHE |
| #define CONFIG_CMD_DFU |
| #define CONFIG_CMD_DHCP |
| #define CONFIG_CMD_EXT4 |
| #define CONFIG_CMD_EXT4_WRITE |
| #define CONFIG_CMD_FAT |
| #define CONFIG_CMD_FPGA |
| #define CONFIG_CMD_FS_GENERIC |
| #define CONFIG_CMD_GREPENV |
| #define CONFIG_CMD_MII |
| #define CONFIG_CMD_MMC |
| #define CONFIG_CMD_NET |
| #define CONFIG_CMD_PING |
| #define CONFIG_CMD_SETEXPR |
| #define CONFIG_CMD_USB |
| #define CONFIG_CMD_USB_MASS_STORAGE |
| |
| |
| /* Memory configurations */ |
| #define PHYS_SDRAM_1_SIZE 0x40000000 /* 1GiB on SoCDK */ |
| |
| /* Booting Linux */ |
| #define CONFIG_BOOTDELAY 3 |
| #define CONFIG_BOOTFILE "zImage" |
| #define CONFIG_BOOTARGS "console=ttyS0," __stringify(CONFIG_BAUDRATE) |
| #ifdef CONFIG_SOCFPGA_VIRTUAL_TARGET |
| #define CONFIG_BOOTCOMMAND "run ramboot" |
| #else |
| #define CONFIG_BOOTCOMMAND "run mmcload; run mmcboot" |
| #endif |
| #define CONFIG_LOADADDR 0x8000 |
| #define CONFIG_SYS_LOAD_ADDR CONFIG_LOADADDR |
| |
| /* Ethernet on SoC (EMAC) */ |
| #if defined(CONFIG_CMD_NET) |
| #define CONFIG_EMAC_BASE SOCFPGA_EMAC1_ADDRESS |
| #define CONFIG_PHY_INTERFACE_MODE PHY_INTERFACE_MODE_RGMII |
| |
| /* PHY */ |
| #define CONFIG_PHY_MICREL |
| #define CONFIG_PHY_MICREL_KSZ9021 |
| #define CONFIG_KSZ9021_CLK_SKEW_ENV "micrel-ksz9021-clk-skew" |
| #define CONFIG_KSZ9021_CLK_SKEW_VAL 0xf0f0 |
| #define CONFIG_KSZ9021_DATA_SKEW_ENV "micrel-ksz9021-data-skew" |
| #define CONFIG_KSZ9021_DATA_SKEW_VAL 0x0 |
| |
| #endif |
| |
| /* USB */ |
| #ifdef CONFIG_CMD_USB |
| #define CONFIG_USB_DWC2_REG_ADDR SOCFPGA_USB1_ADDRESS |
| #endif |
| #define CONFIG_G_DNL_MANUFACTURER "Altera" |
| |
| /* Extra Environment */ |
| #define CONFIG_HOSTNAME socfpga_cyclone5 |
| |
| #define CONFIG_EXTRA_ENV_SETTINGS \ |
| "verify=n\0" \ |
| "loadaddr= " __stringify(CONFIG_SYS_LOAD_ADDR) "\0" \ |
| "ramboot=setenv bootargs " CONFIG_BOOTARGS ";" \ |
| "bootm ${loadaddr} - ${fdt_addr}\0" \ |
| "bootimage=zImage\0" \ |
| "fdt_addr=100\0" \ |
| "fdtimage=socfpga.dtb\0" \ |
| "fsloadcmd=ext2load\0" \ |
| "bootm ${loadaddr} - ${fdt_addr}\0" \ |
| "mmcroot=/dev/mmcblk0p2\0" \ |
| "mmcboot=setenv bootargs " CONFIG_BOOTARGS \ |
| " root=${mmcroot} rw rootwait;" \ |
| "bootz ${loadaddr} - ${fdt_addr}\0" \ |
| "mmcload=mmc rescan;" \ |
| "load mmc 0:1 ${loadaddr} ${bootimage};" \ |
| "load mmc 0:1 ${fdt_addr} ${fdtimage}\0" \ |
| "qspiroot=/dev/mtdblock0\0" \ |
| "qspirootfstype=jffs2\0" \ |
| "qspiboot=setenv bootargs " CONFIG_BOOTARGS \ |
| " root=${qspiroot} rw rootfstype=${qspirootfstype};"\ |
| "bootm ${loadaddr} - ${fdt_addr}\0" |
| |
| /* The rest of the configuration is shared */ |
| #include <configs/socfpga_common.h> |
| |
| #endif /* __CONFIG_SOCFPGA_CYCLONE5_H__ */ |