| /* Initializes CPU and basic hardware such as memory |
| * controllers, IRQ controller and system timer 0. |
| * |
| * (C) Copyright 2007, 2015 |
| * Daniel Hellstrom, Cobham Gaisler, daniel@gaisler.com |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #include <common.h> |
| #include <asm/asi.h> |
| #include <asm/leon.h> |
| #include <asm/io.h> |
| |
| #include <config.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| /* |
| * Breath some life into the CPU... |
| * |
| * Set up the memory map, |
| * initialize a bunch of registers. |
| * |
| * Run from FLASH/PROM: |
| * - until memory controller is set up, only registers available |
| * - no global variables available for writing |
| * - constants available |
| */ |
| |
| void cpu_init_f(void) |
| { |
| LEON2_regs *leon2 = (LEON2_regs *) LEON2_PREGS; |
| |
| /* initialize the IRQMP */ |
| leon2->Interrupt_Force = 0; |
| leon2->Interrupt_Pending = 0; |
| leon2->Interrupt_Clear = 0xfffe; /* clear all old pending interrupts */ |
| leon2->Interrupt_Mask = 0xfffe0000; /* mask all IRQs */ |
| |
| /* cache */ |
| |
| /* I/O port setup */ |
| #ifdef LEON2_IO_PORT_DIR |
| leon2->PIO_Direction = LEON2_IO_PORT_DIR; |
| #endif |
| #ifdef LEON2_IO_PORT_DATA |
| leon2->PIO_Data = LEON2_IO_PORT_DATA; |
| #endif |
| #ifdef LEON2_IO_PORT_INT |
| leon2->PIO_Interrupt = LEON2_IO_PORT_INT; |
| #else |
| leon2->PIO_Interrupt = 0; |
| #endif |
| |
| /* disable timers */ |
| leon2->Timer_Control_1 = leon2->Timer_Control_2 = 0; |
| } |
| |
| int arch_cpu_init(void) |
| { |
| gd->cpu_clk = CONFIG_SYS_CLK_FREQ; |
| gd->bus_clk = CONFIG_SYS_CLK_FREQ; |
| gd->ram_size = CONFIG_SYS_SDRAM_SIZE; |
| |
| return 0; |
| } |
| |
| /* |
| * initialize higher level parts of CPU |
| */ |
| int cpu_init_r(void) |
| { |
| return 0; |
| } |
| |
| /* initiate and setup timer0 to configured HZ. Base clock is 1MHz. |
| */ |
| int timer_init(void) |
| { |
| LEON2_regs *leon2 = (LEON2_regs *)LEON2_PREGS; |
| |
| /* initialize prescaler common to all timers to 1MHz */ |
| leon2->Scaler_Counter = leon2->Scaler_Reload = |
| (((CONFIG_SYS_CLK_FREQ / 1000) + 500) / 1000) - 1; |
| |
| /* SYS_HZ ticks per second */ |
| leon2->Timer_Counter_1 = 0; |
| leon2->Timer_Reload_1 = (CONFIG_SYS_TIMER_RATE / CONFIG_SYS_HZ) - 1; |
| leon2->Timer_Control_1 = LEON2_TIMER_CTRL_EN | LEON2_TIMER_CTRL_RS | |
| LEON2_TIMER_CTRL_LD; |
| |
| CONFIG_SYS_TIMER_COUNTER = (void *)&leon2->Timer_Counter_1; |
| return 0; |
| } |