| /* |
| * Copyright (C) 2012-2015 Masahiro Yamada <yamada.masahiro@socionext.com> |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #include <common.h> |
| #include <linux/ctype.h> |
| #include <linux/io.h> |
| |
| #include "micro-support-card.h" |
| |
| #define MICRO_SUPPORT_CARD_BASE 0x43f00000 |
| #define SMC911X_BASE ((MICRO_SUPPORT_CARD_BASE) + 0x00000) |
| #define LED_BASE ((MICRO_SUPPORT_CARD_BASE) + 0x90000) |
| #define NS16550A_BASE ((MICRO_SUPPORT_CARD_BASE) + 0xb0000) |
| #define MICRO_SUPPORT_CARD_RESET ((MICRO_SUPPORT_CARD_BASE) + 0xd0034) |
| #define MICRO_SUPPORT_CARD_REVISION ((MICRO_SUPPORT_CARD_BASE) + 0xd00E0) |
| |
| /* |
| * 0: reset deassert, 1: reset |
| * |
| * bit[0]: LAN, I2C, LED |
| * bit[1]: UART |
| */ |
| void support_card_reset_deassert(void) |
| { |
| writel(0, MICRO_SUPPORT_CARD_RESET); |
| } |
| |
| void support_card_reset(void) |
| { |
| writel(3, MICRO_SUPPORT_CARD_RESET); |
| } |
| |
| static int support_card_show_revision(void) |
| { |
| u32 revision; |
| |
| revision = readl(MICRO_SUPPORT_CARD_REVISION); |
| printf("(CPLD version %d.%d)\n", revision >> 4, revision & 0xf); |
| return 0; |
| } |
| |
| int check_support_card(void) |
| { |
| printf("SC: Micro Support Card "); |
| return support_card_show_revision(); |
| } |
| |
| void support_card_init(void) |
| { |
| /* |
| * After power on, we need to keep the LAN controller in reset state |
| * for a while. (200 usec) |
| * Fortunately, enough wait time is already inserted in pll_init() |
| * function. So we do not have to wait here. |
| */ |
| support_card_reset_deassert(); |
| } |
| |
| #if defined(CONFIG_SMC911X) |
| #include <netdev.h> |
| |
| int board_eth_init(bd_t *bis) |
| { |
| return smc911x_initialize(0, SMC911X_BASE); |
| } |
| #endif |
| |
| #if !defined(CONFIG_SYS_NO_FLASH) |
| |
| #include <mtd/cfi_flash.h> |
| |
| struct memory_bank { |
| phys_addr_t base; |
| unsigned long size; |
| }; |
| |
| static int mem_is_flash(const struct memory_bank *mem) |
| { |
| const int loop = 128; |
| u32 *scratch_addr; |
| u32 saved_value; |
| int ret = 1; |
| int i; |
| |
| /* just in case, use the tail of the memory bank */ |
| scratch_addr = map_physmem(mem->base + mem->size - sizeof(u32) * loop, |
| sizeof(u32) * loop, MAP_NOCACHE); |
| |
| for (i = 0; i < loop; i++, scratch_addr++) { |
| saved_value = readl(scratch_addr); |
| writel(~saved_value, scratch_addr); |
| if (readl(scratch_addr) != saved_value) { |
| /* We assume no memory or SRAM here. */ |
| writel(saved_value, scratch_addr); |
| ret = 0; |
| break; |
| } |
| } |
| |
| unmap_physmem(scratch_addr, MAP_NOCACHE); |
| |
| return ret; |
| } |
| |
| /* {address, size} */ |
| static const struct memory_bank memory_banks[] = { |
| {0x42000000, 0x01f00000}, |
| }; |
| |
| static const struct memory_bank |
| *flash_banks_list[CONFIG_SYS_MAX_FLASH_BANKS_DETECT]; |
| |
| phys_addr_t cfi_flash_bank_addr(int i) |
| { |
| return flash_banks_list[i]->base; |
| } |
| |
| unsigned long cfi_flash_bank_size(int i) |
| { |
| return flash_banks_list[i]->size; |
| } |
| |
| static void detect_num_flash_banks(void) |
| { |
| const struct memory_bank *memory_bank, *end; |
| |
| cfi_flash_num_flash_banks = 0; |
| |
| memory_bank = memory_banks; |
| end = memory_bank + ARRAY_SIZE(memory_banks); |
| |
| for (; memory_bank < end; memory_bank++) { |
| if (cfi_flash_num_flash_banks >= |
| CONFIG_SYS_MAX_FLASH_BANKS_DETECT) |
| break; |
| |
| if (mem_is_flash(memory_bank)) { |
| flash_banks_list[cfi_flash_num_flash_banks] = |
| memory_bank; |
| |
| debug("flash bank found: base = 0x%lx, size = 0x%lx\n", |
| memory_bank->base, memory_bank->size); |
| cfi_flash_num_flash_banks++; |
| } |
| } |
| |
| debug("number of flash banks: %d\n", cfi_flash_num_flash_banks); |
| } |
| #else /* CONFIG_SYS_NO_FLASH */ |
| void detect_num_flash_banks(void) |
| { |
| }; |
| #endif /* CONFIG_SYS_NO_FLASH */ |
| |
| void support_card_late_init(void) |
| { |
| detect_num_flash_banks(); |
| } |
| |
| static const u8 ledval_num[] = { |
| 0x7e, /* 0 */ |
| 0x0c, /* 1 */ |
| 0xb6, /* 2 */ |
| 0x9e, /* 3 */ |
| 0xcc, /* 4 */ |
| 0xda, /* 5 */ |
| 0xfa, /* 6 */ |
| 0x4e, /* 7 */ |
| 0xfe, /* 8 */ |
| 0xde, /* 9 */ |
| }; |
| |
| static const u8 ledval_alpha[] = { |
| 0xee, /* A */ |
| 0xf8, /* B */ |
| 0x72, /* C */ |
| 0xbc, /* D */ |
| 0xf2, /* E */ |
| 0xe2, /* F */ |
| 0x7a, /* G */ |
| 0xe8, /* H */ |
| 0x08, /* I */ |
| 0x3c, /* J */ |
| 0xea, /* K */ |
| 0x70, /* L */ |
| 0x6e, /* M */ |
| 0xa8, /* N */ |
| 0xb8, /* O */ |
| 0xe6, /* P */ |
| 0xce, /* Q */ |
| 0xa0, /* R */ |
| 0xc8, /* S */ |
| 0x8c, /* T */ |
| 0x7c, /* U */ |
| 0x54, /* V */ |
| 0xfc, /* W */ |
| 0xec, /* X */ |
| 0xdc, /* Y */ |
| 0xa4, /* Z */ |
| }; |
| |
| static u8 char2ledval(char c) |
| { |
| if (isdigit(c)) |
| return ledval_num[c - '0']; |
| else if (isalpha(c)) |
| return ledval_alpha[toupper(c) - 'A']; |
| |
| return 0; |
| } |
| |
| void led_puts(const char *s) |
| { |
| int i; |
| u32 val = 0; |
| |
| if (!s) |
| return; |
| |
| for (i = 0; i < 4; i++) { |
| val <<= 8; |
| val |= char2ledval(*s); |
| if (*s != '\0') |
| s++; |
| } |
| |
| writel(~val, LED_BASE); |
| } |