| /* |
| * (C) Copyright 2009 |
| * Matthias Fuchs, esd gmbh, matthias.fuchs@esd.eu |
| * |
| * (C) Copyright 2006 |
| * Sylvie Gohl, AMCC/IBM, gohl.sylvie@fr.ibm.com |
| * Jacqueline Pira-Ferriol, AMCC/IBM, jpira-ferriol@fr.ibm.com |
| * Thierry Roman, AMCC/IBM, thierry_roman@fr.ibm.com |
| * Alain Saurel, AMCC/IBM, alain.saurel@fr.ibm.com |
| * Robert Snyder, AMCC/IBM, rob.snyder@fr.ibm.com |
| * |
| * (C) Copyright 2006-2007 |
| * Stefan Roese, DENX Software Engineering, sr@denx.de. |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| /* define DEBUG for debug output */ |
| #undef DEBUG |
| |
| #include <common.h> |
| #include <asm/processor.h> |
| #include <asm/io.h> |
| #include <asm/mmu.h> |
| #include <asm/ppc440.h> |
| |
| extern int denali_wait_for_dlllock(void); |
| extern void denali_core_search_data_eye(void); |
| |
| struct sdram_conf_s { |
| ulong size; |
| int rows; |
| int banks; |
| }; |
| |
| struct sdram_conf_s sdram_conf[] = { |
| {(1024 << 20), 14, 8}, /* 1GByte: 4x2GBit, 14x10, 8 banks */ |
| {(512 << 20), 13, 8}, /* 512MByte: 4x1GBit, 13x10, 8 banks */ |
| {(256 << 20), 13, 4}, /* 256MByte: 4x512MBit, 13x10, 4 banks */ |
| }; |
| |
| /* |
| * initdram -- 440EPx's DDR controller is a DENALI Core |
| */ |
| int initdram_by_rb(int rows, int banks) |
| { |
| ulong speed = get_bus_freq(0); |
| |
| mtsdram(DDR0_02, 0x00000000); |
| |
| mtsdram(DDR0_00, 0x0000190A); |
| mtsdram(DDR0_01, 0x01000000); |
| mtsdram(DDR0_03, 0x02030602); |
| mtsdram(DDR0_04, 0x0A020200); |
| mtsdram(DDR0_05, 0x02020308); |
| mtsdram(DDR0_06, 0x0102C812); |
| mtsdram(DDR0_07, 0x000D0100); |
| mtsdram(DDR0_08, 0x02430001); |
| mtsdram(DDR0_09, 0x00011D5F); |
| mtsdram(DDR0_10, 0x00000100); |
| mtsdram(DDR0_11, 0x0027C800); |
| mtsdram(DDR0_12, 0x00000003); |
| mtsdram(DDR0_14, 0x00000000); |
| mtsdram(DDR0_17, 0x19000000); |
| mtsdram(DDR0_18, 0x19191919); |
| mtsdram(DDR0_19, 0x19191919); |
| mtsdram(DDR0_20, 0x0B0B0B0B); |
| mtsdram(DDR0_21, 0x0B0B0B0B); |
| mtsdram(DDR0_22, 0x00267F0B); |
| mtsdram(DDR0_23, 0x00000000); |
| mtsdram(DDR0_24, 0x01010002); |
| if (speed > 133333334) |
| mtsdram(DDR0_26, 0x5B26050C); |
| else |
| mtsdram(DDR0_26, 0x5B260408); |
| mtsdram(DDR0_27, 0x0000682B); |
| mtsdram(DDR0_28, 0x00000000); |
| mtsdram(DDR0_31, 0x00000000); |
| |
| mtsdram(DDR0_42, |
| DDR0_42_ADDR_PINS_DECODE(14 - rows) | |
| 0x00000006); |
| mtsdram(DDR0_43, |
| DDR0_43_EIGHT_BANK_MODE_ENCODE(8 == banks ? 1 : 0) | |
| 0x030A0200); |
| |
| mtsdram(DDR0_44, 0x00000003); |
| mtsdram(DDR0_02, 0x00000001); |
| |
| denali_wait_for_dlllock(); |
| |
| #ifdef CONFIG_DDR_DATA_EYE |
| /* |
| * Perform data eye search if requested. |
| */ |
| denali_core_search_data_eye(); |
| #endif |
| /* |
| * Clear possible errors resulting from data-eye-search. |
| * If not done, then we could get an interrupt later on when |
| * exceptions are enabled. |
| */ |
| set_mcsr(get_mcsr()); |
| |
| return 0; |
| } |
| |
| phys_size_t initdram(int board_type) |
| { |
| phys_size_t size; |
| int n; |
| |
| /* go through supported memory configurations */ |
| for (n = 0; n < ARRAY_SIZE(sdram_conf); n++) { |
| size = sdram_conf[n].size; |
| |
| /* program TLB entries */ |
| program_tlb(0, CONFIG_SYS_SDRAM_BASE, size, |
| TLB_WORD2_I_ENABLE); |
| |
| /* |
| * setup denali core |
| */ |
| initdram_by_rb(sdram_conf[n].rows, |
| sdram_conf[n].banks); |
| |
| /* check for suitable configuration */ |
| if (get_ram_size(CONFIG_SYS_SDRAM_BASE, size) == size) |
| return size; |
| |
| /* delete TLB entries */ |
| remove_tlb(CONFIG_SYS_SDRAM_BASE, size); |
| } |
| |
| return 0; |
| } |