| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright (C) 2012-2017 Altera Corporation <www.altera.com> |
| */ |
| |
| #include <common.h> |
| #include <cpu_func.h> |
| #include <asm/io.h> |
| #include <errno.h> |
| #include <fdtdec.h> |
| #include <linux/libfdt.h> |
| #include <altera.h> |
| #include <miiphy.h> |
| #include <netdev.h> |
| #include <watchdog.h> |
| #include <asm/arch/misc.h> |
| #include <asm/arch/reset_manager.h> |
| #include <asm/arch/scan_manager.h> |
| #include <asm/arch/system_manager.h> |
| #include <asm/arch/nic301.h> |
| #include <asm/arch/scu.h> |
| #include <asm/pl310.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| phys_addr_t socfpga_clkmgr_base __section(".data"); |
| phys_addr_t socfpga_rstmgr_base __section(".data"); |
| phys_addr_t socfpga_sysmgr_base __section(".data"); |
| |
| #ifdef CONFIG_SYS_L2_PL310 |
| static const struct pl310_regs *const pl310 = |
| (struct pl310_regs *)CONFIG_SYS_PL310_BASE; |
| #endif |
| |
| struct bsel bsel_str[] = { |
| { "rsvd", "Reserved", }, |
| { "fpga", "FPGA (HPS2FPGA Bridge)", }, |
| { "nand", "NAND Flash (1.8V)", }, |
| { "nand", "NAND Flash (3.0V)", }, |
| { "sd", "SD/MMC External Transceiver (1.8V)", }, |
| { "sd", "SD/MMC Internal Transceiver (3.0V)", }, |
| { "qspi", "QSPI Flash (1.8V)", }, |
| { "qspi", "QSPI Flash (3.0V)", }, |
| }; |
| |
| int dram_init(void) |
| { |
| if (fdtdec_setup_mem_size_base() != 0) |
| return -EINVAL; |
| |
| return 0; |
| } |
| |
| void enable_caches(void) |
| { |
| #if !CONFIG_IS_ENABLED(SYS_ICACHE_OFF) |
| icache_enable(); |
| #endif |
| #if !CONFIG_IS_ENABLED(SYS_DCACHE_OFF) |
| dcache_enable(); |
| #endif |
| } |
| |
| #ifdef CONFIG_SYS_L2_PL310 |
| void v7_outer_cache_enable(void) |
| { |
| struct udevice *dev; |
| |
| if (uclass_get_device(UCLASS_CACHE, 0, &dev)) |
| pr_err("cache controller driver NOT found!\n"); |
| } |
| |
| void v7_outer_cache_disable(void) |
| { |
| /* Disable the L2 cache */ |
| clrbits_le32(&pl310->pl310_ctrl, L2X0_CTRL_EN); |
| } |
| |
| void socfpga_pl310_clear(void) |
| { |
| u32 mask = 0xff, ena = 0; |
| |
| icache_enable(); |
| |
| /* Disable the L2 cache */ |
| clrbits_le32(&pl310->pl310_ctrl, L2X0_CTRL_EN); |
| |
| writel(0x0, &pl310->pl310_tag_latency_ctrl); |
| writel(0x10, &pl310->pl310_data_latency_ctrl); |
| |
| /* enable BRESP, instruction and data prefetch, full line of zeroes */ |
| setbits_le32(&pl310->pl310_aux_ctrl, |
| L310_AUX_CTRL_DATA_PREFETCH_MASK | |
| L310_AUX_CTRL_INST_PREFETCH_MASK | |
| L310_SHARED_ATT_OVERRIDE_ENABLE); |
| |
| /* Enable the L2 cache */ |
| ena = readl(&pl310->pl310_ctrl); |
| ena |= L2X0_CTRL_EN; |
| |
| /* |
| * Invalidate the PL310 L2 cache. Keep the invalidation code |
| * entirely in L1 I-cache to avoid any bus traffic through |
| * the L2. |
| */ |
| asm volatile( |
| ".align 5 \n" |
| " b 3f \n" |
| "1: str %1, [%4] \n" |
| " dsb \n" |
| " isb \n" |
| " str %0, [%2] \n" |
| " dsb \n" |
| " isb \n" |
| "2: ldr %0, [%2] \n" |
| " cmp %0, #0 \n" |
| " bne 2b \n" |
| " str %0, [%3] \n" |
| " dsb \n" |
| " isb \n" |
| " b 4f \n" |
| "3: b 1b \n" |
| "4: nop \n" |
| : "+r"(mask), "+r"(ena) |
| : "r"(&pl310->pl310_inv_way), |
| "r"(&pl310->pl310_cache_sync), "r"(&pl310->pl310_ctrl) |
| : "memory", "cc"); |
| |
| /* Disable the L2 cache */ |
| clrbits_le32(&pl310->pl310_ctrl, L2X0_CTRL_EN); |
| } |
| #endif |
| |
| #if defined(CONFIG_SYS_CONSOLE_IS_IN_ENV) && \ |
| defined(CONFIG_SYS_CONSOLE_OVERWRITE_ROUTINE) |
| int overwrite_console(void) |
| { |
| return 0; |
| } |
| #endif |
| |
| #ifdef CONFIG_FPGA |
| /* add device descriptor to FPGA device table */ |
| void socfpga_fpga_add(void *fpga_desc) |
| { |
| fpga_init(); |
| fpga_add(fpga_altera, fpga_desc); |
| } |
| #endif |
| |
| int arch_cpu_init(void) |
| { |
| socfpga_get_managers_addr(); |
| |
| #ifdef CONFIG_HW_WATCHDOG |
| /* |
| * In case the watchdog is enabled, make sure to (re-)configure it |
| * so that the defined timeout is valid. Otherwise the SPL (Perloader) |
| * timeout value is still active which might too short for Linux |
| * booting. |
| */ |
| hw_watchdog_init(); |
| #else |
| /* |
| * If the HW watchdog is NOT enabled, make sure it is not running, |
| * for example because it was enabled in the preloader. This might |
| * trigger a watchdog-triggered reboot of Linux kernel later. |
| * Toggle watchdog reset, so watchdog in not running state. |
| */ |
| socfpga_per_reset(SOCFPGA_RESET(L4WD0), 1); |
| socfpga_per_reset(SOCFPGA_RESET(L4WD0), 0); |
| #endif |
| |
| return 0; |
| } |
| |
| #ifndef CONFIG_SPL_BUILD |
| static int do_bridge(cmd_tbl_t *cmdtp, int flag, int argc, char * const argv[]) |
| { |
| unsigned int mask = ~0; |
| |
| if (argc < 2 || argc > 3) |
| return CMD_RET_USAGE; |
| |
| argv++; |
| |
| if (argc == 3) |
| mask = simple_strtoul(argv[1], NULL, 16); |
| |
| switch (*argv[0]) { |
| case 'e': /* Enable */ |
| do_bridge_reset(1, mask); |
| break; |
| case 'd': /* Disable */ |
| do_bridge_reset(0, mask); |
| break; |
| default: |
| return CMD_RET_USAGE; |
| } |
| |
| return 0; |
| } |
| |
| U_BOOT_CMD(bridge, 3, 1, do_bridge, |
| "SoCFPGA HPS FPGA bridge control", |
| "enable [mask] - Enable HPS-to-FPGA, FPGA-to-HPS, LWHPS-to-FPGA bridges\n" |
| "bridge disable [mask] - Enable HPS-to-FPGA, FPGA-to-HPS, LWHPS-to-FPGA bridges\n" |
| "" |
| ); |
| |
| #endif |
| |
| static int socfpga_get_base_addr(const char *compat, phys_addr_t *base) |
| { |
| const void *blob = gd->fdt_blob; |
| struct fdt_resource r; |
| int node; |
| int ret; |
| |
| node = fdt_node_offset_by_compatible(blob, -1, compat); |
| if (node < 0) |
| return node; |
| |
| if (!fdtdec_get_is_enabled(blob, node)) |
| return -ENODEV; |
| |
| ret = fdt_get_resource(blob, node, "reg", 0, &r); |
| if (ret) |
| return ret; |
| |
| *base = (phys_addr_t)r.start; |
| |
| return 0; |
| } |
| |
| void socfpga_get_managers_addr(void) |
| { |
| int ret; |
| |
| ret = socfpga_get_base_addr("altr,rst-mgr", &socfpga_rstmgr_base); |
| if (ret) |
| hang(); |
| |
| ret = socfpga_get_base_addr("altr,sys-mgr", &socfpga_sysmgr_base); |
| if (ret) |
| hang(); |
| |
| ret = socfpga_get_base_addr("altr,clk-mgr", &socfpga_clkmgr_base); |
| if (ret) |
| hang(); |
| } |
| |
| phys_addr_t socfpga_get_rstmgr_addr(void) |
| { |
| return socfpga_rstmgr_base; |
| } |
| |
| phys_addr_t socfpga_get_sysmgr_addr(void) |
| { |
| return socfpga_sysmgr_base; |
| } |
| |
| phys_addr_t socfpga_get_clkmgr_addr(void) |
| { |
| return socfpga_clkmgr_base; |
| } |