blob: 3da72fdad279f9c89bccb7bfec15342d30c0f297 [file] [log] [blame]
How to use U-Boot on NXP i.MXRT1020 EVK
-----------------------------------------------
- Build U-Boot for i.MXRT1020 EVK:
$ make mrproper
$ make imxrt1020-evk_defconfig
$ make
This will generate the SPL image called SPL and the u-boot.img.
- Flash the SPL image into the micro SD card:
sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
- Flash the u-boot.img image into the micro SD card:
sudo dd if=u-boot.img of=/dev/sdb bs=1k seek=128; sync
- Jumper settings:
SW8: 0 1 1 0
where 0 means bottom position and 1 means top position (from the
switch label numbers reference).
- Connect the USB cable between the EVK and the PC for the console.
(The USB console connector is the one close the ethernet connector)
- Insert the micro SD card in the board, power it up and U-Boot messages should
come up.