| /* |
| * Copyright (C) 2013-2014 Synopsys, Inc. All rights reserved. |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #ifndef _CONFIG_AXS101_H_ |
| #define _CONFIG_AXS101_H_ |
| |
| /* |
| * CPU configuration |
| */ |
| #define CONFIG_SYS_TIMER_RATE CONFIG_SYS_CLK_FREQ |
| |
| #define ARC_FPGA_PERIPHERAL_BASE 0xE0000000 |
| #define ARC_APB_PERIPHERAL_BASE 0xF0000000 |
| #define ARC_DWMMC_BASE (ARC_FPGA_PERIPHERAL_BASE + 0x15000) |
| #define ARC_DWGMAC_BASE (ARC_FPGA_PERIPHERAL_BASE + 0x18000) |
| |
| /* |
| * Memory configuration |
| */ |
| #define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_TEXT_BASE |
| |
| #define CONFIG_SYS_DDR_SDRAM_BASE 0x80000000 |
| #define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE |
| #define CONFIG_SYS_SDRAM_SIZE 0x20000000 /* 512 Mb */ |
| |
| #define CONFIG_SYS_INIT_SP_ADDR \ |
| (CONFIG_SYS_SDRAM_BASE + 0x1000 - GENERATED_GBL_DATA_SIZE) |
| |
| #define CONFIG_SYS_MALLOC_LEN 0x200000 /* 2 MB */ |
| #define CONFIG_SYS_BOOTM_LEN 0x2000000 /* 32 MB */ |
| #define CONFIG_SYS_LOAD_ADDR 0x82000000 |
| |
| /* |
| * This board might be of different versions so handle it |
| */ |
| #define CONFIG_BOARD_TYPES |
| #define CONFIG_BOARD_EARLY_INIT_F |
| |
| /* |
| * NAND Flash configuration |
| */ |
| #define CONFIG_SYS_NO_FLASH |
| #define CONFIG_SYS_NAND_BASE (ARC_FPGA_PERIPHERAL_BASE + 0x16000) |
| #define CONFIG_SYS_MAX_NAND_DEVICE 1 |
| |
| /* |
| * UART configuration |
| */ |
| #define CONFIG_DW_SERIAL |
| #define CONFIG_SYS_NS16550_SERIAL |
| #define CONFIG_SYS_NS16550_CLK 33333333 |
| #define CONFIG_SYS_NS16550_MEM32 |
| #define CONFIG_BAUDRATE 115200 |
| |
| /* |
| * I2C configuration |
| */ |
| #define CONFIG_SYS_I2C |
| #define CONFIG_SYS_I2C_DW |
| #define CONFIG_I2C_ENV_EEPROM_BUS 2 |
| #define CONFIG_SYS_I2C_SPEED 100000 |
| #define CONFIG_SYS_I2C_SPEED1 100000 |
| #define CONFIG_SYS_I2C_SPEED2 100000 |
| #define CONFIG_SYS_I2C_SLAVE 0 |
| #define CONFIG_SYS_I2C_SLAVE1 0 |
| #define CONFIG_SYS_I2C_SLAVE2 0 |
| #define CONFIG_SYS_I2C_BASE 0xE001D000 |
| #define CONFIG_SYS_I2C_BASE1 0xE001E000 |
| #define CONFIG_SYS_I2C_BASE2 0xE001F000 |
| #define CONFIG_SYS_I2C_BUS_MAX 3 |
| #define IC_CLK 50 |
| |
| /* |
| * EEPROM configuration |
| */ |
| #define CONFIG_SYS_I2C_EEPROM_ADDR (0xA8 >> 1) |
| #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1 |
| #define CONFIG_SYS_I2C_EEPROM_ADDR_OVERFLOW 1 |
| #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3 |
| #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 64 |
| |
| /* |
| * SD/MMC configuration |
| */ |
| #define CONFIG_MMC |
| #define CONFIG_GENERIC_MMC |
| #define CONFIG_DWMMC |
| #define CONFIG_DOS_PARTITION |
| |
| /* |
| * Ethernet PHY configuration |
| */ |
| #define CONFIG_MII |
| #define CONFIG_PHY_GIGE |
| |
| /* |
| * USB 1.1 configuration |
| */ |
| #define CONFIG_USB_OHCI_NEW |
| #define CONFIG_SYS_USB_OHCI_MAX_ROOT_PORTS 1 |
| |
| /* |
| * Commands still not supported in Kconfig |
| */ |
| #define CONFIG_CMD_NAND |
| |
| #define CONFIG_AUTO_COMPLETE |
| #define CONFIG_SYS_MAXARGS 16 |
| |
| /* |
| * Environment settings |
| */ |
| #define CONFIG_ENV_IS_IN_EEPROM |
| #define CONFIG_ENV_SIZE 0x00200 /* 512 bytes */ |
| #define CONFIG_ENV_OFFSET 0 |
| |
| /* |
| * Environment configuration |
| */ |
| #define CONFIG_BOOTDELAY 3 |
| #define CONFIG_BOOTFILE "uImage" |
| #define CONFIG_BOOTARGS "console=ttyS3,115200n8" |
| #define CONFIG_LOADADDR CONFIG_SYS_LOAD_ADDR |
| |
| /* |
| * Console configuration |
| */ |
| #define CONFIG_SYS_LONGHELP |
| #define CONFIG_SYS_CBSIZE 256 |
| #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE |
| #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + \ |
| sizeof(CONFIG_SYS_PROMPT) + 16) |
| |
| /* |
| * Misc utility configuration |
| */ |
| #define CONFIG_BOUNCE_BUFFER |
| |
| #endif /* _CONFIG_AXS101_H_ */ |