| /* |
| * SPDX-License-Identifier: GPL-2.0 IBM-pibs |
| */ |
| /*----------------------------------------------------------------------------- |
| * Function: ext_bus_cntlr_init |
| * Description: Initializes the External Bus Controller for the external |
| * peripherals. IMPORTANT: For pass1 this code must run from |
| * cache since you can not reliably change a peripheral banks |
| * timing register (pbxap) while running code from that bank. |
| * For ex., since we are running from ROM on bank 0, we can NOT |
| * execute the code that modifies bank 0 timings from ROM, so |
| * we run it from cache. |
| * Bank 0 - Flash or Multi Purpose Socket |
| * Bank 1 - Multi Purpose Socket or Flash (set in C-Code) |
| * Bank 2 - UART 1 (set in C-Code) |
| * Bank 3 - UART 2 (set in C-Code) |
| * Bank 4 - not used |
| * Bank 5 - not used |
| * Bank 6 - not used |
| * Bank 7 - PLD Register |
| *-----------------------------------------------------------------------------*/ |
| |
| #include <configs/MIP405.h> |
| #include <ppc_asm.tmpl> |
| #include <ppc_defs.h> |
| |
| #include <asm/cache.h> |
| #include <asm/mmu.h> |
| #include <asm/ppc4xx.h> |
| #include "mip405.h" |
| |
| |
| .globl ext_bus_cntlr_init |
| ext_bus_cntlr_init: |
| mflr r4 /* save link register */ |
| mfdcr r3,CPC0_PSR /* get strapping reg */ |
| andi. r0, r3, PSR_ROM_LOC /* mask out irrelevant bits */ |
| bnelr /* jump back if PCI boot */ |
| |
| bl ..getAddr |
| ..getAddr: |
| mflr r3 /* get address of ..getAddr */ |
| mtlr r4 /* restore link register */ |
| addi r4,0,14 /* set ctr to 14; used to prefetch */ |
| mtctr r4 /* 14 cache lines to fit this function */ |
| /* in cache (gives us 8x14=112 instrctns) */ |
| ..ebcloop: |
| icbt r0,r3 /* prefetch cache line for addr in r3 */ |
| addi r3,r3,32 /* move to next cache line */ |
| bdnz ..ebcloop /* continue for 14 cache lines */ |
| |
| /*------------------------------------------------------------------- |
| * Delay to ensure all accesses to ROM are complete before changing |
| * bank 0 timings. |
| *------------------------------------------------------------------- */ |
| addis r3,0,0x0 |
| ori r3,r3,0xA000 |
| mtctr r3 |
| ..spinlp: |
| bdnz ..spinlp /* spin loop */ |
| |
| /*----------------------------------------------------------------------- |
| * decide boot up mode |
| *----------------------------------------------------------------------- */ |
| addi r4,0,PB0CR |
| mtdcr EBC0_CFGADDR,r4 |
| mfdcr r4,EBC0_CFGDATA |
| |
| andi. r0, r4, 0x2000 /* mask out irrelevant bits */ |
| beq 0f /* jump if 8 bit bus width */ |
| |
| /* setup 16 bit things |
| *----------------------------------------------------------------------- |
| * Memory Bank 0 (16 Bit Flash) initialization |
| *---------------------------------------------------------------------- */ |
| |
| addi r4,0,PB1AP |
| mtdcr EBC0_CFGADDR,r4 |
| addis r4,0,(FLASH_AP_B)@h |
| ori r4,r4,(FLASH_AP_B)@l |
| mtdcr EBC0_CFGDATA,r4 |
| |
| addi r4,0,PB0CR |
| mtdcr EBC0_CFGADDR,r4 |
| /* BS=0x010(4MB),BU=0x3(R/W), */ |
| addis r4,0,(FLASH_CR_B)@h |
| ori r4,r4,(FLASH_CR_B)@l |
| mtdcr EBC0_CFGDATA,r4 |
| b 1f |
| |
| 0: |
| |
| /* 8Bit boot mode: */ |
| /*----------------------------------------------------------------------- |
| * Memory Bank 0 Multi Purpose Socket initialization |
| *----------------------------------------------------------------------- */ |
| /* 0x7F8FFE80 slowest boot */ |
| addi r4,0,PB1AP |
| mtdcr EBC0_CFGADDR,r4 |
| addis r4,0,(MPS_AP_B)@h |
| ori r4,r4,(MPS_AP_B)@l |
| mtdcr EBC0_CFGDATA,r4 |
| |
| addi r4,0,PB0CR |
| mtdcr EBC0_CFGADDR,r4 |
| /* BS=0x010(4MB),BU=0x3(R/W), */ |
| addis r4,0,(MPS_CR_B)@h |
| ori r4,r4,(MPS_CR_B)@l |
| |
| mtdcr EBC0_CFGDATA,r4 |
| |
| |
| 1: |
| /*----------------------------------------------------------------------- |
| * Memory Bank 2-3-4-5-6 (not used) initialization |
| *-----------------------------------------------------------------------*/ |
| addi r4,0,PB1CR |
| mtdcr EBC0_CFGADDR,r4 |
| addis r4,0,0x0000 |
| ori r4,r4,0x0000 |
| mtdcr EBC0_CFGDATA,r4 |
| |
| addi r4,0,PB2CR |
| mtdcr EBC0_CFGADDR,r4 |
| addis r4,0,0x0000 |
| ori r4,r4,0x0000 |
| mtdcr EBC0_CFGDATA,r4 |
| |
| addi r4,0,PB3CR |
| mtdcr EBC0_CFGADDR,r4 |
| addis r4,0,0x0000 |
| ori r4,r4,0x0000 |
| mtdcr EBC0_CFGDATA,r4 |
| |
| addi r4,0,PB4CR |
| mtdcr EBC0_CFGADDR,r4 |
| addis r4,0,0x0000 |
| ori r4,r4,0x0000 |
| mtdcr EBC0_CFGDATA,r4 |
| |
| addi r4,0,PB5CR |
| mtdcr EBC0_CFGADDR,r4 |
| addis r4,0,0x0000 |
| ori r4,r4,0x0000 |
| mtdcr EBC0_CFGDATA,r4 |
| |
| addi r4,0,PB6CR |
| mtdcr EBC0_CFGADDR,r4 |
| addis r4,0,0x0000 |
| ori r4,r4,0x0000 |
| mtdcr EBC0_CFGDATA,r4 |
| |
| addi r4,0,PB7CR |
| mtdcr EBC0_CFGADDR,r4 |
| addis r4,0,0x0000 |
| ori r4,r4,0x0000 |
| mtdcr EBC0_CFGDATA,r4 |
| nop /* pass2 DCR errata #8 */ |
| blr |
| |
| #if defined(CONFIG_BOOT_PCI) |
| .section .bootpg,"ax" |
| .globl _start_pci |
| /******************************************* |
| */ |
| |
| _start_pci: |
| /* first handle errata #68 / PCI_18 */ |
| iccci r0, r0 /* invalidate I-cache */ |
| lis r31, 0 |
| mticcr r31 /* ICCR = 0 (all uncachable) */ |
| isync |
| |
| mfccr0 r28 /* set CCR0[24] = 1 */ |
| ori r28, r28, 0x0080 |
| mtccr0 r28 |
| |
| /* setup PMM0MA (0xEF400004) and PMM0PCIHA (0xEF40000C) */ |
| lis r28, 0xEF40 |
| addi r28, r28, 0x0004 |
| stw r31, 0x0C(r28) /* clear PMM0PCIHA */ |
| lis r29, 0xFFF8 /* open 512 kByte */ |
| addi r29, r29, 0x0001/* and enable this region */ |
| stwbrx r29, r0, r28 /* write PMM0MA */ |
| |
| lis r28, 0xEEC0 /* address of PCIC0_CFGADDR */ |
| addi r29, r28, 4 /* add 4 to r29 -> PCIC0_CFGDATA */ |
| |
| lis r31, 0x8000 /* set en bit bus 0 */ |
| ori r31, r31, 0x304C/* device 6 func 0 reg 4C (XBCS register) */ |
| stwbrx r31, r0, r28 /* write it */ |
| |
| lwbrx r31, r0, r29 /* load XBCS register */ |
| oris r31, r31, 0x02C4/* clear BIOSCS WPE, set lower, extended and 1M extended BIOS enable */ |
| stwbrx r31, r0, r29 /* write back XBCS register */ |
| |
| nop |
| nop |
| b _start /* normal start */ |
| #endif |