| /* |
| * Copyright (C) 2014 Panasonic Corporation |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #include <common.h> |
| #include <asm/io.h> |
| #include <asm/unaligned.h> |
| #include <linux/mtd/nand.h> |
| #include "denali.h" |
| |
| #define SPARE_ACCESS 0x41 |
| #define MAIN_ACCESS 0x42 |
| #define PIPELINE_ACCESS 0x2000 |
| |
| #define BANK(x) ((x) << 24) |
| |
| static void __iomem *denali_flash_mem = |
| (void __iomem *)CONFIG_SYS_NAND_DATA_BASE; |
| static void __iomem *denali_flash_reg = |
| (void __iomem *)CONFIG_SYS_NAND_REGS_BASE; |
| |
| static const int flash_bank; |
| static uint8_t page_buffer[NAND_MAX_PAGESIZE]; |
| static int page_size, oob_size, pages_per_block; |
| |
| static void index_addr(uint32_t address, uint32_t data) |
| { |
| writel(address, denali_flash_mem + INDEX_CTRL_REG); |
| writel(data, denali_flash_mem + INDEX_DATA_REG); |
| } |
| |
| static int wait_for_irq(uint32_t irq_mask) |
| { |
| unsigned long timeout = 1000000; |
| uint32_t intr_status; |
| |
| do { |
| intr_status = readl(denali_flash_reg + INTR_STATUS(flash_bank)); |
| |
| if (intr_status & INTR_STATUS__ECC_UNCOR_ERR) { |
| debug("Uncorrected ECC detected\n"); |
| return -EIO; |
| } |
| |
| if (intr_status & irq_mask) |
| break; |
| |
| udelay(1); |
| timeout--; |
| } while (timeout); |
| |
| if (!timeout) { |
| debug("Timeout with interrupt status %08x\n", intr_status); |
| return -EIO; |
| } |
| |
| return 0; |
| } |
| |
| static void read_data_from_flash_mem(uint8_t *buf, int len) |
| { |
| int i; |
| uint32_t *buf32; |
| |
| /* transfer the data from the flash */ |
| buf32 = (uint32_t *)buf; |
| |
| /* |
| * Let's take care of unaligned access although it rarely happens. |
| * Avoid put_unaligned() for the normal use cases since it leads to |
| * a bit performance regression. |
| */ |
| if ((unsigned long)buf32 % 4) { |
| for (i = 0; i < len / 4; i++) |
| put_unaligned(readl(denali_flash_mem + INDEX_DATA_REG), |
| buf32++); |
| } else { |
| for (i = 0; i < len / 4; i++) |
| *buf32++ = readl(denali_flash_mem + INDEX_DATA_REG); |
| } |
| |
| if (len % 4) { |
| u32 tmp; |
| |
| tmp = cpu_to_le32(readl(denali_flash_mem + INDEX_DATA_REG)); |
| buf = (uint8_t *)buf32; |
| for (i = 0; i < len % 4; i++) { |
| *buf++ = tmp; |
| tmp >>= 8; |
| } |
| } |
| } |
| |
| int denali_send_pipeline_cmd(int page, int ecc_en, int access_type) |
| { |
| uint32_t addr, cmd; |
| static uint32_t page_count = 1; |
| |
| writel(ecc_en, denali_flash_reg + ECC_ENABLE); |
| |
| /* clear all bits of intr_status. */ |
| writel(0xffff, denali_flash_reg + INTR_STATUS(flash_bank)); |
| |
| addr = BANK(flash_bank) | page; |
| |
| /* setup the acccess type */ |
| cmd = MODE_10 | addr; |
| index_addr(cmd, access_type); |
| |
| /* setup the pipeline command */ |
| index_addr(cmd, PIPELINE_ACCESS | page_count); |
| |
| cmd = MODE_01 | addr; |
| writel(cmd, denali_flash_mem + INDEX_CTRL_REG); |
| |
| return wait_for_irq(INTR_STATUS__LOAD_COMP); |
| } |
| |
| static int nand_read_oob(void *buf, int page) |
| { |
| int ret; |
| |
| ret = denali_send_pipeline_cmd(page, 0, SPARE_ACCESS); |
| if (ret < 0) |
| return ret; |
| |
| read_data_from_flash_mem(buf, oob_size); |
| |
| return 0; |
| } |
| |
| static int nand_read_page(void *buf, int page) |
| { |
| int ret; |
| |
| ret = denali_send_pipeline_cmd(page, 1, MAIN_ACCESS); |
| if (ret < 0) |
| return ret; |
| |
| read_data_from_flash_mem(buf, page_size); |
| |
| return 0; |
| } |
| |
| static int nand_block_isbad(int block) |
| { |
| int ret; |
| |
| ret = nand_read_oob(page_buffer, block * pages_per_block); |
| if (ret < 0) |
| return ret; |
| |
| return page_buffer[CONFIG_SYS_NAND_BAD_BLOCK_POS] != 0xff; |
| } |
| |
| /* nand_init() - initialize data to make nand usable by SPL */ |
| void nand_init(void) |
| { |
| /* access to main area */ |
| writel(0, denali_flash_reg + TRANSFER_SPARE_REG); |
| |
| /* |
| * These registers are expected to be already set by the hardware |
| * or earlier boot code. So we read these values out. |
| */ |
| page_size = readl(denali_flash_reg + DEVICE_MAIN_AREA_SIZE); |
| oob_size = readl(denali_flash_reg + DEVICE_SPARE_AREA_SIZE); |
| pages_per_block = readl(denali_flash_reg + PAGES_PER_BLOCK); |
| } |
| |
| int nand_spl_load_image(uint32_t offs, unsigned int size, void *dst) |
| { |
| int block, page, column, readlen; |
| int ret; |
| int force_bad_block_check = 1; |
| |
| page = offs / page_size; |
| column = offs % page_size; |
| |
| block = page / pages_per_block; |
| page = page % pages_per_block; |
| |
| while (size) { |
| if (force_bad_block_check || page == 0) { |
| ret = nand_block_isbad(block); |
| if (ret < 0) |
| return ret; |
| |
| if (ret) { |
| block++; |
| continue; |
| } |
| } |
| |
| force_bad_block_check = 0; |
| |
| if (unlikely(column || size < page_size)) { |
| /* Partial page read */ |
| ret = nand_read_page(page_buffer, |
| block * pages_per_block + page); |
| if (ret < 0) |
| return ret; |
| |
| readlen = min(page_size - column, (int)size); |
| memcpy(dst, page_buffer, readlen); |
| |
| column = 0; |
| } else { |
| ret = nand_read_page(dst, |
| block * pages_per_block + page); |
| if (ret < 0) |
| return ret; |
| |
| readlen = page_size; |
| } |
| |
| size -= readlen; |
| dst += readlen; |
| page++; |
| if (page == pages_per_block) { |
| block++; |
| page = 0; |
| } |
| } |
| |
| return 0; |
| } |
| |
| void nand_deselect(void) {} |