| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * Copyright 2022 NXP |
| */ |
| |
| #include <common.h> |
| #include <clk.h> |
| #include <cpu_func.h> |
| #include <dm.h> |
| #include <errno.h> |
| #include <eth_phy.h> |
| #include <log.h> |
| #include <malloc.h> |
| #include <memalign.h> |
| #include <miiphy.h> |
| #include <net.h> |
| #include <netdev.h> |
| #include <phy.h> |
| #include <reset.h> |
| #include <wait_bit.h> |
| #include <asm/arch/clock.h> |
| #include <asm/cache.h> |
| #include <asm/gpio.h> |
| #include <asm/io.h> |
| #include <asm/mach-imx/sys_proto.h> |
| #include <linux/delay.h> |
| |
| #include "dwc_eth_qos.h" |
| |
| __weak u32 imx_get_eqos_csr_clk(void) |
| { |
| return 100 * 1000000; |
| } |
| |
| __weak int imx_eqos_txclk_set_rate(unsigned long rate) |
| { |
| return 0; |
| } |
| |
| static ulong eqos_get_tick_clk_rate_imx(struct udevice *dev) |
| { |
| return imx_get_eqos_csr_clk(); |
| } |
| |
| static int eqos_probe_resources_imx(struct udevice *dev) |
| { |
| struct eqos_priv *eqos = dev_get_priv(dev); |
| phy_interface_t interface; |
| |
| debug("%s(dev=%p):\n", __func__, dev); |
| |
| interface = eqos->config->interface(dev); |
| |
| if (interface == PHY_INTERFACE_MODE_NA) { |
| pr_err("Invalid PHY interface\n"); |
| return -EINVAL; |
| } |
| |
| debug("%s: OK\n", __func__); |
| return 0; |
| } |
| |
| static int eqos_set_tx_clk_speed_imx(struct udevice *dev) |
| { |
| struct eqos_priv *eqos = dev_get_priv(dev); |
| ulong rate; |
| int ret; |
| |
| debug("%s(dev=%p):\n", __func__, dev); |
| |
| switch (eqos->phy->speed) { |
| case SPEED_1000: |
| rate = 125 * 1000 * 1000; |
| break; |
| case SPEED_100: |
| rate = 25 * 1000 * 1000; |
| break; |
| case SPEED_10: |
| rate = 2.5 * 1000 * 1000; |
| break; |
| default: |
| pr_err("invalid speed %d", eqos->phy->speed); |
| return -EINVAL; |
| } |
| |
| ret = imx_eqos_txclk_set_rate(rate); |
| if (ret < 0) { |
| pr_err("imx (tx_clk, %lu) failed: %d", rate, ret); |
| return ret; |
| } |
| |
| return 0; |
| } |
| |
| static int eqos_get_enetaddr_imx(struct udevice *dev) |
| { |
| struct eth_pdata *pdata = dev_get_plat(dev); |
| |
| imx_get_mac_from_fuse(dev_seq(dev), pdata->enetaddr); |
| |
| return 0; |
| } |
| |
| static struct eqos_ops eqos_imx_ops = { |
| .eqos_inval_desc = eqos_inval_desc_generic, |
| .eqos_flush_desc = eqos_flush_desc_generic, |
| .eqos_inval_buffer = eqos_inval_buffer_generic, |
| .eqos_flush_buffer = eqos_flush_buffer_generic, |
| .eqos_probe_resources = eqos_probe_resources_imx, |
| .eqos_remove_resources = eqos_null_ops, |
| .eqos_stop_resets = eqos_null_ops, |
| .eqos_start_resets = eqos_null_ops, |
| .eqos_stop_clks = eqos_null_ops, |
| .eqos_start_clks = eqos_null_ops, |
| .eqos_calibrate_pads = eqos_null_ops, |
| .eqos_disable_calibration = eqos_null_ops, |
| .eqos_set_tx_clk_speed = eqos_set_tx_clk_speed_imx, |
| .eqos_get_enetaddr = eqos_get_enetaddr_imx, |
| .eqos_get_tick_clk_rate = eqos_get_tick_clk_rate_imx, |
| }; |
| |
| struct eqos_config __maybe_unused eqos_imx_config = { |
| .reg_access_always_ok = false, |
| .mdio_wait = 10, |
| .swr_wait = 50, |
| .config_mac = EQOS_MAC_RXQ_CTRL0_RXQ0EN_ENABLED_DCB, |
| .config_mac_mdio = EQOS_MAC_MDIO_ADDRESS_CR_250_300, |
| .axi_bus_width = EQOS_AXI_WIDTH_64, |
| .interface = dev_read_phy_mode, |
| .ops = &eqos_imx_ops |
| }; |