| /* |
| * Copyright (C) 2013 Altera Corporation <www.altera.com> |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| |
| #include <common.h> |
| #include <asm/io.h> |
| #include <asm/arch/reset_manager.h> |
| #include <asm/arch/fpga_manager.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| static const struct socfpga_reset_manager *reset_manager_base = |
| (void *)SOCFPGA_RSTMGR_ADDRESS; |
| |
| /* Toggle reset signal to watchdog (WDT is disabled after this operation!) */ |
| void socfpga_watchdog_reset(void) |
| { |
| /* assert reset for watchdog */ |
| setbits_le32(&reset_manager_base->per_mod_reset, |
| 1 << RSTMGR_PERMODRST_L4WD0_LSB); |
| |
| /* deassert watchdog from reset (watchdog in not running state) */ |
| clrbits_le32(&reset_manager_base->per_mod_reset, |
| 1 << RSTMGR_PERMODRST_L4WD0_LSB); |
| } |
| |
| /* |
| * Write the reset manager register to cause reset |
| */ |
| void reset_cpu(ulong addr) |
| { |
| /* request a warm reset */ |
| writel((1 << RSTMGR_CTRL_SWWARMRSTREQ_LSB), |
| &reset_manager_base->ctrl); |
| /* |
| * infinite loop here as watchdog will trigger and reset |
| * the processor |
| */ |
| while (1) |
| ; |
| } |
| |
| /* |
| * Release peripherals from reset based on handoff |
| */ |
| void reset_deassert_peripherals_handoff(void) |
| { |
| writel(0, &reset_manager_base->per_mod_reset); |
| } |
| |
| #if defined(CONFIG_SOCFPGA_VIRTUAL_TARGET) |
| void socfpga_bridges_reset(int enable) |
| { |
| /* For SoCFPGA-VT, this is NOP. */ |
| } |
| #else |
| |
| #define L3REGS_REMAP_LWHPS2FPGA_MASK 0x10 |
| #define L3REGS_REMAP_HPS2FPGA_MASK 0x08 |
| #define L3REGS_REMAP_OCRAM_MASK 0x01 |
| |
| void socfpga_bridges_reset(int enable) |
| { |
| const uint32_t l3mask = L3REGS_REMAP_LWHPS2FPGA_MASK | |
| L3REGS_REMAP_HPS2FPGA_MASK | |
| L3REGS_REMAP_OCRAM_MASK; |
| |
| if (enable) { |
| /* brdmodrst */ |
| writel(0xffffffff, &reset_manager_base->brg_mod_reset); |
| } else { |
| /* Check signal from FPGA. */ |
| if (fpgamgr_poll_fpga_ready()) { |
| /* FPGA not ready. Wait for watchdog timeout. */ |
| printf("%s: fpga not ready, hanging.\n", __func__); |
| hang(); |
| } |
| |
| /* brdmodrst */ |
| writel(0, &reset_manager_base->brg_mod_reset); |
| |
| /* Remap the bridges into memory map */ |
| writel(l3mask, SOCFPGA_L3REGS_ADDRESS); |
| } |
| } |
| #endif |
| |
| /* Change the reset state for EMAC 0 and EMAC 1 */ |
| void socfpga_emac_reset(int enable) |
| { |
| const void *reset = &reset_manager_base->per_mod_reset; |
| |
| if (enable) { |
| setbits_le32(reset, 1 << RSTMGR_PERMODRST_EMAC0_LSB); |
| setbits_le32(reset, 1 << RSTMGR_PERMODRST_EMAC1_LSB); |
| } else { |
| #if (CONFIG_EMAC_BASE == SOCFPGA_EMAC0_ADDRESS) |
| clrbits_le32(reset, 1 << RSTMGR_PERMODRST_EMAC0_LSB); |
| #elif (CONFIG_EMAC_BASE == SOCFPGA_EMAC1_ADDRESS) |
| clrbits_le32(reset, 1 << RSTMGR_PERMODRST_EMAC1_LSB); |
| #endif |
| } |
| } |
| |
| /* SPI Master enable (its held in reset by the preloader) */ |
| void socfpga_spim_enable(void) |
| { |
| const void *reset = &reset_manager_base->per_mod_reset; |
| |
| clrbits_le32(reset, (1 << RSTMGR_PERMODRST_SPIM0_LSB) | |
| (1 << RSTMGR_PERMODRST_SPIM1_LSB)); |
| } |
| |
| /* Bring UART0 out of reset. */ |
| void socfpga_uart0_enable(void) |
| { |
| const void *reset = &reset_manager_base->per_mod_reset; |
| |
| clrbits_le32(reset, 1 << RSTMGR_PERMODRST_UART0_LSB); |
| } |
| |
| /* Bring SDRAM controller out of reset. */ |
| void socfpga_sdram_enable(void) |
| { |
| const void *reset = &reset_manager_base->per_mod_reset; |
| |
| clrbits_le32(reset, 1 << RSTMGR_PERMODRST_SDR_LSB); |
| } |
| |
| /* Bring OSC1 timer out of reset. */ |
| void socfpga_osc1timer_enable(void) |
| { |
| const void *reset = &reset_manager_base->per_mod_reset; |
| |
| clrbits_le32(reset, 1 << RSTMGR_PERMODRST_OSC1TIMER0_LSB); |
| } |