blob: d7a19c6772ce18ddb61c43533e195462b6648351 [file] [log] [blame]
if ARCH_UNIPHIER
config SYS_CONFIG_NAME
default "uniphier"
config UNIPHIER_SMP
bool
choice
prompt "UniPhier SoC select"
default ARCH_UNIPHIER_PH1_PRO4
config ARCH_UNIPHIER_PH1_SLD3
bool "PH1-sLD3"
select UNIPHIER_SMP
config ARCH_UNIPHIER_PH1_LD4
bool "PH1-LD4"
config ARCH_UNIPHIER_PH1_PRO4
bool "PH1-Pro4"
select UNIPHIER_SMP
config ARCH_UNIPHIER_PH1_SLD8
bool "PH1-sLD8"
endchoice
config MICRO_SUPPORT_CARD
bool "Use Micro Support Card"
help
This option provides support for the expansion board, available
on some UniPhier reference boards.
Say Y to use the on-board UART, Ether, LED devices.
config CMD_PINMON
bool "Enable boot mode pins monitor command"
default y
help
The command "pinmon" shows the state of the boot mode pins.
The boot mode pins are latched when the system reset is deasserted
and determine which device the system should load a boot image from.
config CMD_DDRPHY_DUMP
bool "Enable dump command of DDR PHY parameters"
help
The command "ddrphy" shows the resulting parameters of DDR PHY
training; it is useful for the evaluation of DDR PHY training.
choice
prompt "DDR3 Frequency select"
config DDR_FREQ_1600
bool "DDR3 1600"
depends on ARCH_UNIPHIER_PH1_SLD3 || ARCH_UNIPHIER_PH1_LD4 || ARCH_UNIPHIER_PH1_PRO4
config DDR_FREQ_1333
bool "DDR3 1333"
depends on ARCH_UNIPHIER_PH1_SLD3 || ARCH_UNIPHIER_PH1_LD4 || ARCH_UNIPHIER_PH1_SLD8
endchoice
config DDR_FREQ
int
default 1333 if DDR_FREQ_1333
default 1600 if DDR_FREQ_1600
endif