| /* |
| * (C) Copyright 2008 |
| * Sergei Poselenov, Emcraft Systems, sposelenov@emcraft.com. |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #include <common.h> |
| #include <asm/processor.h> |
| #include <asm/immap_85xx.h> |
| #include <fsl_ddr_sdram.h> |
| #include <asm/processor.h> |
| #include <asm/mmu.h> |
| #include <spd_sdram.h> |
| |
| |
| #if !defined(CONFIG_SPD_EEPROM) |
| /* |
| * Autodetect onboard DDR SDRAM on 85xx platforms |
| * |
| * NOTE: Some of the hardcoded values are hardware dependant, |
| * so this should be extended for other future boards |
| * using this routine! |
| */ |
| phys_size_t fixed_sdram(void) |
| { |
| struct ccsr_ddr __iomem *ddr = |
| (struct ccsr_ddr __iomem *)(CONFIG_SYS_FSL_DDR_ADDR); |
| |
| /* |
| * Disable memory controller. |
| */ |
| ddr->cs0_config = 0; |
| ddr->sdram_cfg = 0; |
| |
| ddr->cs0_bnds = CONFIG_SYS_DDR_CS0_BNDS; |
| ddr->cs0_config = CONFIG_SYS_DDR_CS0_CONFIG; |
| ddr->timing_cfg_0 = CONFIG_SYS_DDR_TIMING_0; |
| ddr->timing_cfg_1 = CONFIG_SYS_DDR_TIMING_1; |
| ddr->timing_cfg_2 = CONFIG_SYS_DDR_TIMING_2; |
| ddr->sdram_mode = CONFIG_SYS_DDR_MODE; |
| ddr->sdram_interval = CONFIG_SYS_DDR_INTERVAL; |
| ddr->sdram_cfg_2 = CONFIG_SYS_DDR_CONFIG_2; |
| ddr->sdram_clk_cntl = CONFIG_SYS_DDR_CLK_CONTROL; |
| |
| asm ("sync;isync;msync"); |
| udelay(1000); |
| |
| ddr->sdram_cfg = CONFIG_SYS_DDR_CONFIG; |
| asm ("sync; isync; msync"); |
| udelay(1000); |
| |
| if (get_ram_size(0, CONFIG_SYS_SDRAM_SIZE<<20) == CONFIG_SYS_SDRAM_SIZE<<20) { |
| /* |
| * OK, size detected -> all done |
| */ |
| return CONFIG_SYS_SDRAM_SIZE<<20; |
| } |
| |
| return 0; /* nothing found ! */ |
| } |
| #endif |
| |
| #if defined(CONFIG_SYS_DRAM_TEST) |
| int testdram (void) |
| { |
| uint *pstart = (uint *) CONFIG_SYS_MEMTEST_START; |
| uint *pend = (uint *) CONFIG_SYS_MEMTEST_END; |
| uint *p; |
| |
| printf ("SDRAM test phase 1:\n"); |
| for (p = pstart; p < pend; p++) |
| *p = 0xaaaaaaaa; |
| |
| for (p = pstart; p < pend; p++) { |
| if (*p != 0xaaaaaaaa) { |
| printf ("SDRAM test fails at: %08x\n", (uint) p); |
| return 1; |
| } |
| } |
| |
| printf ("SDRAM test phase 2:\n"); |
| for (p = pstart; p < pend; p++) |
| *p = 0x55555555; |
| |
| for (p = pstart; p < pend; p++) { |
| if (*p != 0x55555555) { |
| printf ("SDRAM test fails at: %08x\n", (uint) p); |
| return 1; |
| } |
| } |
| |
| printf ("SDRAM test passed.\n"); |
| return 0; |
| } |
| #endif |