| CONFIG_ARM=y |
| CONFIG_ARCH_CPU_INIT=y |
| CONFIG_ARCH_OMAP2PLUS=y |
| CONFIG_SPL_GPIO=y |
| CONFIG_SPL_LIBCOMMON_SUPPORT=y |
| CONFIG_SPL_LIBGENERIC_SUPPORT=y |
| CONFIG_ENV_SIZE=0x1000 |
| CONFIG_ENV_OFFSET=0x7000 |
| CONFIG_DEFAULT_DEVICE_TREE="am335x-shc" |
| CONFIG_AM33XX=y |
| CONFIG_TARGET_AM335X_SHC=y |
| CONFIG_SPL_MMC=y |
| CONFIG_SPL_SERIAL=y |
| CONFIG_SPL=y |
| CONFIG_ENV_OFFSET_REDUND=0x9000 |
| CONFIG_SPL_FS_FAT=y |
| CONFIG_SPL_LIBDISK_SUPPORT=y |
| CONFIG_SHC_SDBOOT=y |
| CONFIG_SERIES=y |
| CONFIG_TIMESTAMP=y |
| CONFIG_SYS_BOOTM_LEN=0x1000000 |
| CONFIG_DISTRO_DEFAULTS=y |
| CONFIG_SHOW_BOOT_PROGRESS=y |
| CONFIG_AUTOBOOT_KEYED=y |
| CONFIG_AUTOBOOT_PROMPT="Enter 'shc' to enter prompt (times out) %d \nEnter 'noautoboot' to enter prompt without timeout\n" |
| CONFIG_AUTOBOOT_DELAY_STR="shc" |
| CONFIG_AUTOBOOT_STOP_STR="noautoboot" |
| CONFIG_BOOT_RETRY=y |
| CONFIG_BOOT_RETRY_TIME=30 |
| CONFIG_RESET_TO_RETRY=y |
| CONFIG_BOOTCOMMAND="if mmc dev 0; mmc rescan; then run sd_setup; else echo ERROR: SD/MMC-Card not detected!; panic; fi; if run loaduimage; then echo Bootable SD/MMC-Card inserted, booting from it!; run mmcboot; else echo ERROR: Unable to load uImage from SD/MMC-Card!; panic; fi; " |
| CONFIG_DEFAULT_FDT_FILE="am335x-shc" |
| CONFIG_SYS_PBSIZE=1049 |
| CONFIG_SYS_CONSOLE_INFO_QUIET=y |
| CONFIG_SPL_BOARD_INIT=y |
| CONFIG_SPL_SYS_MALLOC_SIMPLE=y |
| CONFIG_SPL_SYS_MALLOC=y |
| CONFIG_SPL_SYS_MALLOC_SIZE=0x800000 |
| CONFIG_SPL_FS_EXT4=y |
| CONFIG_SPL_I2C=y |
| # CONFIG_SPL_NAND_SUPPORT is not set |
| CONFIG_SPL_OS_BOOT=y |
| CONFIG_SPL_FALCON_BOOT_MMCSD=y |
| CONFIG_SYS_MMCSD_RAW_MODE_KERNEL_SECTOR=0x1700 |
| CONFIG_SYS_MMCSD_RAW_MODE_ARGS_SECTOR=0x1500 |
| CONFIG_SYS_MMCSD_RAW_MODE_ARGS_SECTORS=0x200 |
| CONFIG_SPL_POWER=y |
| CONFIG_SPL_WATCHDOG=y |
| CONFIG_SPL_YMODEM_SUPPORT=y |
| # CONFIG_SPL_AM33XX_ENABLE_RTC32K_OSC is not set |
| CONFIG_SYS_PROMPT="U-Boot# " |
| CONFIG_CMD_GPIO=y |
| CONFIG_CMD_GPT=y |
| CONFIG_CMD_MMC=y |
| # CONFIG_CMD_PINMUX is not set |
| # CONFIG_CMD_SETEXPR is not set |
| CONFIG_BOOTP_DNS2=y |
| CONFIG_CMD_CACHE=y |
| CONFIG_OF_CONTROL=y |
| CONFIG_ENV_OVERWRITE=y |
| CONFIG_ENV_IS_IN_MMC=y |
| CONFIG_SYS_REDUNDAND_ENVIRONMENT=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG=y |
| CONFIG_VERSION_VARIABLE=y |
| CONFIG_NET_RETRY_COUNT=10 |
| CONFIG_BOOTP_SEND_HOSTNAME=y |
| CONFIG_DM_I2C=y |
| CONFIG_SPL_SYS_I2C_LEGACY=y |
| CONFIG_SYS_I2C_SLAVE=0x1 |
| CONFIG_SYS_I2C_SPEED=400000 |
| CONFIG_MISC=y |
| CONFIG_I2C_EEPROM=y |
| CONFIG_MMC_OMAP_HS=y |
| CONFIG_HSMMC2_8BIT=y |
| CONFIG_PHY_ADDR_ENABLE=y |
| CONFIG_PHY_SMSC=y |
| CONFIG_MII=y |
| CONFIG_DRIVER_TI_CPSW=y |
| CONFIG_PINCTRL=y |
| CONFIG_PINCTRL_SINGLE=y |
| CONFIG_PMIC_TPS65217=y |
| CONFIG_LZO=y |