blob: c2a8593b39f51518a3f7da8f7ee0ed741be6a134 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* Meson GXL USB3 PHY driver
*
* Copyright (C) 2018 Martin Blumenstingl <martin.blumenstingl@googlemail.com>
* Copyright (C) 2018 BayLibre, SAS
* Author: Neil Armstrong <narmstron@baylibre.com>
*/
#include <common.h>
#include <malloc.h>
#include <asm/io.h>
#include <bitfield.h>
#include <dm.h>
#include <errno.h>
#include <generic-phy.h>
#include <regmap.h>
#include <clk.h>
#include <linux/bitops.h>
#include <linux/compat.h>
#include <linux/bitfield.h>
#define USB_R0 0x00
#define USB_R0_P30_FSEL_MASK GENMASK(5, 0)
#define USB_R0_P30_PHY_RESET BIT(6)
#define USB_R0_P30_TEST_POWERDOWN_HSP BIT(7)
#define USB_R0_P30_TEST_POWERDOWN_SSP BIT(8)
#define USB_R0_P30_ACJT_LEVEL_MASK GENMASK(13, 9)
#define USB_R0_P30_TX_BOOST_LEVEL_MASK GENMASK(16, 14)
#define USB_R0_P30_LANE0_TX2RX_LOOPBACK BIT(17)
#define USB_R0_P30_LANE0_EXT_PCLK_REQ BIT(18)
#define USB_R0_P30_PCS_RX_LOS_MASK_VAL_MASK GENMASK(28, 19)
#define USB_R0_U2D_SS_SCALEDOWN_MODE_MASK GENMASK(30, 29)
#define USB_R0_U2D_ACT BIT(31)
#define USB_R1 0x04
#define USB_R1_U3H_BIGENDIAN_GS BIT(0)
#define USB_R1_U3H_PME_ENABLE BIT(1)
#define USB_R1_U3H_HUB_PORT_OVERCURRENT_MASK GENMASK(6, 2)
#define USB_R1_U3H_HUB_PORT_PERM_ATTACH_MASK GENMASK(11, 7)
#define USB_R1_U3H_HOST_U2_PORT_DISABLE_MASK GENMASK(15, 12)
#define USB_R1_U3H_HOST_U3_PORT_DISABLE BIT(16)
#define USB_R1_U3H_HOST_PORT_POWER_CONTROL_PRESENT BIT(17)
#define USB_R1_U3H_HOST_MSI_ENABLE BIT(18)
#define USB_R1_U3H_FLADJ_30MHZ_REG_MASK GENMASK(24, 19)
#define USB_R1_P30_PCS_TX_SWING_FULL_MASK GENMASK(31, 25)
#define USB_R2 0x08
#define USB_R2_P30_CR_DATA_IN_MASK GENMASK(15, 0)
#define USB_R2_P30_CR_READ BIT(16)
#define USB_R2_P30_CR_WRITE BIT(17)
#define USB_R2_P30_CR_CAP_ADDR BIT(18)
#define USB_R2_P30_CR_CAP_DATA BIT(19)
#define USB_R2_P30_PCS_TX_DEEMPH_3P5DB_MASK GENMASK(25, 20)
#define USB_R2_P30_PCS_TX_DEEMPH_6DB_MASK GENMASK(31, 26)
#define USB_R3 0x0c
#define USB_R3_P30_SSC_ENABLE BIT(0)
#define USB_R3_P30_SSC_RANGE_MASK GENMASK(3, 1)
#define USB_R3_P30_SSC_REF_CLK_SEL_MASK GENMASK(12, 4)
#define USB_R3_P30_REF_SSP_EN BIT(13)
#define USB_R3_P30_LOS_BIAS_MASK GENMASK(18, 16)
#define USB_R3_P30_LOS_LEVEL_MASK GENMASK(23, 19)
#define USB_R3_P30_MPLL_MULTIPLIER_MASK GENMASK(30, 24)
#define USB_R4 0x10
#define USB_R4_P21_PORT_RESET_0 BIT(0)
#define USB_R4_P21_SLEEP_M0 BIT(1)
#define USB_R4_MEM_PD_MASK GENMASK(3, 2)
#define USB_R4_P21_ONLY BIT(4)
#define USB_R5 0x14
#define USB_R5_ID_DIG_SYNC BIT(0)
#define USB_R5_ID_DIG_REG BIT(1)
#define USB_R5_ID_DIG_CFG_MASK GENMASK(3, 2)
#define USB_R5_ID_DIG_EN_0 BIT(4)
#define USB_R5_ID_DIG_EN_1 BIT(5)
#define USB_R5_ID_DIG_CURR BIT(6)
#define USB_R5_ID_DIG_IRQ BIT(7)
#define USB_R5_ID_DIG_TH_MASK GENMASK(15, 8)
#define USB_R5_ID_DIG_CNT_MASK GENMASK(23, 16)
/* read-only register */
#define USB_R6 0x18
#define USB_R6_P30_CR_DATA_OUT_MASK GENMASK(15, 0)
#define USB_R6_P30_CR_ACK BIT(16)
struct phy_meson_gxl_usb3_priv {
struct regmap *regmap;
#if CONFIG_IS_ENABLED(CLK)
struct clk clk;
#endif
};
static int
phy_meson_gxl_usb3_set_host_mode(struct phy_meson_gxl_usb3_priv *priv)
{
uint val;
regmap_read(priv->regmap, USB_R0, &val);
val &= ~USB_R0_U2D_ACT;
regmap_write(priv->regmap, USB_R0, val);
regmap_read(priv->regmap, USB_R4, &val);
val &= ~USB_R4_P21_SLEEP_M0;
regmap_write(priv->regmap, USB_R4, val);
return 0;
}
static int phy_meson_gxl_usb3_power_on(struct phy *phy)
{
struct udevice *dev = phy->dev;
struct phy_meson_gxl_usb3_priv *priv = dev_get_priv(dev);
uint val;
regmap_read(priv->regmap, USB_R5, &val);
val |= USB_R5_ID_DIG_EN_0;
val |= USB_R5_ID_DIG_EN_1;
val &= ~USB_R5_ID_DIG_TH_MASK;
val |= FIELD_PREP(USB_R5_ID_DIG_TH_MASK, 0xff);
regmap_write(priv->regmap, USB_R5, val);
return phy_meson_gxl_usb3_set_host_mode(priv);
}
static int phy_meson_gxl_usb3_power_off(struct phy *phy)
{
struct udevice *dev = phy->dev;
struct phy_meson_gxl_usb3_priv *priv = dev_get_priv(dev);
uint val;
regmap_read(priv->regmap, USB_R5, &val);
val &= ~USB_R5_ID_DIG_EN_0;
val &= ~USB_R5_ID_DIG_EN_1;
regmap_write(priv->regmap, USB_R5, val);
return 0;
}
static int phy_meson_gxl_usb3_init(struct phy *phy)
{
struct udevice *dev = phy->dev;
struct phy_meson_gxl_usb3_priv *priv = dev_get_priv(dev);
uint val;
regmap_read(priv->regmap, USB_R1, &val);
val &= ~USB_R1_U3H_FLADJ_30MHZ_REG_MASK;
val |= FIELD_PREP(USB_R1_U3H_FLADJ_30MHZ_REG_MASK, 0x20);
regmap_write(priv->regmap, USB_R1, val);
return 0;
}
struct phy_ops meson_gxl_usb3_phy_ops = {
.init = phy_meson_gxl_usb3_init,
.power_on = phy_meson_gxl_usb3_power_on,
.power_off = phy_meson_gxl_usb3_power_off,
};
int meson_gxl_usb3_phy_probe(struct udevice *dev)
{
struct phy_meson_gxl_usb3_priv *priv = dev_get_priv(dev);
int ret;
ret = regmap_init_mem(dev_ofnode(dev), &priv->regmap);
if (ret)
return ret;
#if CONFIG_IS_ENABLED(CLK)
ret = clk_get_by_index(dev, 0, &priv->clk);
if (ret < 0)
return ret;
ret = clk_enable(&priv->clk);
if (ret && ret != -ENOSYS && ret != -ENOTSUPP) {
pr_err("failed to enable PHY clock\n");
clk_free(&priv->clk);
return ret;
}
#endif
return 0;
}
static const struct udevice_id meson_gxl_usb3_phy_ids[] = {
{ .compatible = "amlogic,meson-gxl-usb3-phy" },
{ }
};
U_BOOT_DRIVER(meson_gxl_usb3_phy) = {
.name = "meson_gxl_usb3_phy",
.id = UCLASS_PHY,
.of_match = meson_gxl_usb3_phy_ids,
.probe = meson_gxl_usb3_phy_probe,
.ops = &meson_gxl_usb3_phy_ops,
.priv_auto_alloc_size = sizeof(struct phy_meson_gxl_usb3_priv),
};