blob: 0447468a2d186815fffab1361cfc4cfa6484929b [file] [log] [blame]
MediaTek xHCI
The device node for USB3 host controller on MediaTek SoCs.
Required properties:
- compatible : should be "mediatek,mtk-xhci"
- reg : specifies physical base address and size of the registers
- reg-names: should be "mac" for xHCI MAC and "ippc" for IP port control
- power-domains : a phandle to USB power domain node to control USB's
MTCMOS
- vusb33-supply : regulator of USB avdd3.3v
- clocks : a list of phandle + clock-specifier pairs, one for each
entry in clock-names
- clock-names : must contain
"sys_ck": controller clock used by normal mode,
the following ones are optional:
"ref_ck": reference clock used by low power mode etc,
"mcu_ck": mcu_bus clock for register access,
"dma_ck": dma_bus clock for data transfer by DMA,
"xhci_ck": controller clock
- phys : list of all the USB PHYs on this HCD
- phy-names: name specifier for the USB PHY
Optional properties:
- vbus-supply : reference to the VBUS regulator;
Example:
xhci: usb@1a0c0000 {
compatible = "mediatek,mt7629-xhci", "mediatek,mtk-xhci";
reg = <0x1a0c0000 0x1000>, <0x1a0c3e00 0x0100>;
reg-names = "mac", "ippc";
power-domains = <&scpsys MT7629_POWER_DOMAIN_HIF1>;
clocks = <&ssusbsys CLK_SSUSB_SYS_EN>, <&ssusbsys CLK_SSUSB_REF_EN>,
<&ssusbsys CLK_SSUSB_MCU_EN>, <&ssusbsys CLK_SSUSB_DMA_EN>;
clock-names = "sys_ck", "ref_ck", "mcu_ck", "dma_ck";
phys = <&u2port0 PHY_TYPE_USB2>, <&u3port0 PHY_TYPE_USB3>;
status = "disabled";
};