| #include <common.h> |
| #include <mpc8xx.h> |
| #include <pcmcia.h> |
| |
| #undef CONFIG_PCMCIA |
| |
| #if defined(CONFIG_CMD_PCMCIA) |
| #define CONFIG_PCMCIA |
| #endif |
| |
| #if defined(CONFIG_CMD_IDE) && defined(CONFIG_IDE_8xx_PCCARD) |
| #define CONFIG_PCMCIA |
| #endif |
| |
| #ifdef CONFIG_PCMCIA |
| |
| #define PCMCIA_BOARD_MSG "GTH COMPACT FLASH" |
| |
| int pcmcia_voltage_set (int slot, int vcc, int vpp) |
| { /* Do nothing */ |
| return 0; |
| } |
| |
| int pcmcia_hardware_enable (int slot) |
| { |
| volatile immap_t *immap; |
| volatile cpm8xx_t *cp; |
| volatile pcmconf8xx_t *pcmp; |
| volatile sysconf8xx_t *sysp; |
| uint reg, mask; |
| |
| debug ("hardware_enable: GTH Slot %c\n", 'A' + slot); |
| |
| immap = (immap_t *) CONFIG_SYS_IMMR; |
| sysp = (sysconf8xx_t *) (&(((immap_t *) CONFIG_SYS_IMMR)->im_siu_conf)); |
| pcmp = (pcmconf8xx_t *) (&(((immap_t *) CONFIG_SYS_IMMR)->im_pcmcia)); |
| cp = (cpm8xx_t *) (&(((immap_t *) CONFIG_SYS_IMMR)->im_cpm)); |
| |
| /* clear interrupt state, and disable interrupts */ |
| pcmp->pcmc_pscr = PCMCIA_MASK (_slot_); |
| pcmp->pcmc_per &= ~PCMCIA_MASK (_slot_); |
| |
| /* |
| * Disable interrupts, DMA, and PCMCIA buffers |
| * (isolate the interface) and assert RESET signal |
| */ |
| debug ("Disable PCMCIA buffers and assert RESET\n"); |
| reg = 0; |
| reg |= __MY_PCMCIA_GCRX_CXRESET; /* active high */ |
| reg |= __MY_PCMCIA_GCRX_CXOE; /* active low */ |
| PCMCIA_PGCRX (_slot_) = reg; |
| udelay (500); |
| |
| /* |
| * Make sure there is a card in the slot, |
| * then configure the interface. |
| */ |
| udelay (10000); |
| debug ("[%d] %s: PIPR(%p)=0x%x\n", |
| __LINE__, __FUNCTION__, |
| &(pcmp->pcmc_pipr), pcmp->pcmc_pipr); |
| if (pcmp->pcmc_pipr & 0x98000000) { |
| printf (" No Card found\n"); |
| return (1); |
| } |
| |
| mask = PCMCIA_VS1 (slot) | PCMCIA_VS2 (slot); |
| reg = pcmp->pcmc_pipr; |
| debug ("PIPR: 0x%x ==> VS1=o%s, VS2=o%s\n", |
| reg, |
| (reg & PCMCIA_VS1 (slot)) ? "n" : "ff", |
| (reg & PCMCIA_VS2 (slot)) ? "n" : "ff"); |
| |
| debug ("Enable PCMCIA buffers and stop RESET\n"); |
| reg = PCMCIA_PGCRX (_slot_); |
| reg &= ~__MY_PCMCIA_GCRX_CXRESET; /* active high */ |
| reg &= ~__MY_PCMCIA_GCRX_CXOE; /* active low */ |
| PCMCIA_PGCRX (_slot_) = reg; |
| |
| udelay (250000); /* some cards need >150 ms to come up :-( */ |
| |
| debug ("# hardware_enable done\n"); |
| |
| return 0; |
| } |
| #if defined(CONFIG_CMD_PCMCIA) |
| int pcmcia_hardware_disable(int slot) |
| { |
| return 0; /* No hardware to disable */ |
| } |
| #endif |
| |
| #endif /* CONFIG_PCMCIA */ |