blob: aa522075691c7b07ecde3f37b60076172a6229f3 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright (C) 2015 Atmel Corporation
* Wenyou.Yang <wenyou.yang@atmel.com>
*/
#include <common.h>
#include <debug_uart.h>
#include <init.h>
#include <asm/global_data.h>
#include <asm/io.h>
#include <asm/arch/at91_common.h>
#include <asm/arch/atmel_pio4.h>
#include <asm/arch/atmel_mpddrc.h>
#include <asm/arch/atmel_sdhci.h>
#include <asm/arch/clk.h>
#include <asm/arch/gpio.h>
#include <asm/arch/sama5d2.h>
extern void at91_pda_detect(void);
DECLARE_GLOBAL_DATA_PTR;
static void rgb_leds_init(void)
{
atmel_pio4_set_pio_output(AT91_PIO_PORTB, 6, 1); /* LED RED */
atmel_pio4_set_pio_output(AT91_PIO_PORTB, 5, 1); /* LED GREEN */
atmel_pio4_set_pio_output(AT91_PIO_PORTB, 0, 0); /* LED BLUE */
}
#ifdef CONFIG_CMD_USB
static void board_usb_hw_init(void)
{
atmel_pio4_set_pio_output(AT91_PIO_PORTB, 10, 1);
}
#endif
#ifdef CONFIG_BOARD_LATE_INIT
int board_late_init(void)
{
#ifdef CONFIG_VIDEO
at91_video_show_board_info();
#endif
at91_pda_detect();
return 0;
}
#endif
#ifdef CONFIG_DEBUG_UART_BOARD_INIT
static void board_uart1_hw_init(void)
{
atmel_pio4_set_a_periph(AT91_PIO_PORTD, 2, ATMEL_PIO_PUEN_MASK); /* URXD1 */
atmel_pio4_set_a_periph(AT91_PIO_PORTD, 3, 0); /* UTXD1 */
at91_periph_clk_enable(ATMEL_ID_UART1);
}
void board_debug_uart_init(void)
{
board_uart1_hw_init();
}
#endif
#ifdef CONFIG_BOARD_EARLY_INIT_F
int board_early_init_f(void)
{
return 0;
}
#endif
int board_init(void)
{
/* address of boot parameters */
gd->bd->bi_boot_params = gd->bd->bi_dram[0].start + 0x100;
rgb_leds_init();
#ifdef CONFIG_CMD_USB
board_usb_hw_init();
#endif
return 0;
}
int dram_init_banksize(void)
{
return fdtdec_setup_memory_banksize();
}
int dram_init(void)
{
return fdtdec_setup_mem_size_base();
}
#define AT24MAC_MAC_OFFSET 0x9a
#ifdef CONFIG_MISC_INIT_R
int misc_init_r(void)
{
#ifdef CONFIG_I2C_EEPROM
at91_set_ethaddr(AT24MAC_MAC_OFFSET);
#endif
return 0;
}
#endif
/* SPL */
#ifdef CONFIG_SPL_BUILD
void spl_board_init(void)
{
}
static void ddrc_conf(struct atmel_mpddrc_config *ddrc)
{
ddrc->md = (ATMEL_MPDDRC_MD_DBW_32_BITS | ATMEL_MPDDRC_MD_DDR3_SDRAM);
ddrc->cr = (ATMEL_MPDDRC_CR_NC_COL_10 |
ATMEL_MPDDRC_CR_NR_ROW_14 |
ATMEL_MPDDRC_CR_CAS_DDR_CAS5 |
ATMEL_MPDDRC_CR_DIC_DS |
ATMEL_MPDDRC_CR_DIS_DLL |
ATMEL_MPDDRC_CR_NB_8BANKS |
ATMEL_MPDDRC_CR_DECOD_INTERLEAVED |
ATMEL_MPDDRC_CR_UNAL_SUPPORTED);
ddrc->rtr = 0x511;
ddrc->tpr0 = (6 << ATMEL_MPDDRC_TPR0_TRAS_OFFSET |
3 << ATMEL_MPDDRC_TPR0_TRCD_OFFSET |
4 << ATMEL_MPDDRC_TPR0_TWR_OFFSET |
9 << ATMEL_MPDDRC_TPR0_TRC_OFFSET |
3 << ATMEL_MPDDRC_TPR0_TRP_OFFSET |
4 << ATMEL_MPDDRC_TPR0_TRRD_OFFSET |
4 << ATMEL_MPDDRC_TPR0_TWTR_OFFSET |
4 << ATMEL_MPDDRC_TPR0_TMRD_OFFSET);
ddrc->tpr1 = (27 << ATMEL_MPDDRC_TPR1_TRFC_OFFSET |
29 << ATMEL_MPDDRC_TPR1_TXSNR_OFFSET |
0 << ATMEL_MPDDRC_TPR1_TXSRD_OFFSET |
3 << ATMEL_MPDDRC_TPR1_TXP_OFFSET);
ddrc->tpr2 = (0 << ATMEL_MPDDRC_TPR2_TXARD_OFFSET |
0 << ATMEL_MPDDRC_TPR2_TXARDS_OFFSET |
0 << ATMEL_MPDDRC_TPR2_TRPA_OFFSET |
4 << ATMEL_MPDDRC_TPR2_TRTP_OFFSET |
7 << ATMEL_MPDDRC_TPR2_TFAW_OFFSET);
}
void mem_init(void)
{
struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
struct atmel_mpddr *mpddrc = (struct atmel_mpddr *)ATMEL_BASE_MPDDRC;
struct atmel_mpddrc_config ddrc_config;
u32 reg;
ddrc_conf(&ddrc_config);
at91_periph_clk_enable(ATMEL_ID_MPDDRC);
writel(AT91_PMC_DDR, &pmc->scer);
reg = readl(&mpddrc->io_calibr);
reg &= ~ATMEL_MPDDRC_IO_CALIBR_RDIV;
reg |= ATMEL_MPDDRC_IO_CALIBR_DDR3_RZQ_55;
reg &= ~ATMEL_MPDDRC_IO_CALIBR_TZQIO;
reg |= ATMEL_MPDDRC_IO_CALIBR_TZQIO_(100);
writel(reg, &mpddrc->io_calibr);
writel(ATMEL_MPDDRC_RD_DATA_PATH_SHIFT_TWO_CYCLE,
&mpddrc->rd_data_path);
ddr3_init(ATMEL_BASE_MPDDRC, ATMEL_BASE_DDRCS, &ddrc_config);
writel(0x3, &mpddrc->cal_mr4);
writel(64, &mpddrc->tim_cal);
}
void at91_pmc_init(void)
{
struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
u32 tmp;
/*
* while coming from the ROM code, we run on PLLA @ 492 MHz / 164 MHz
* so we need to slow down and configure MCKR accordingly.
* This is why we have a special flavor of the switching function.
*/
tmp = AT91_PMC_MCKR_PLLADIV_2 |
AT91_PMC_MCKR_MDIV_3 |
AT91_PMC_MCKR_CSS_MAIN;
at91_mck_init_down(tmp);
tmp = AT91_PMC_PLLAR_29 |
AT91_PMC_PLLXR_PLLCOUNT(0x3f) |
AT91_PMC_PLLXR_MUL(82) |
AT91_PMC_PLLXR_DIV(1);
at91_plla_init(tmp);
writel(0x0 << 8, &pmc->pllicpr);
tmp = AT91_PMC_MCKR_H32MXDIV |
AT91_PMC_MCKR_PLLADIV_2 |
AT91_PMC_MCKR_MDIV_3 |
AT91_PMC_MCKR_CSS_PLLA;
at91_mck_init(tmp);
}
#endif