| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * Copyright 2022 NXP |
| */ |
| |
| #include <clk.h> |
| #include <cpu_func.h> |
| #include <dm.h> |
| #include <dm/device_compat.h> |
| #include <errno.h> |
| #include <eth_phy.h> |
| #include <log.h> |
| #include <malloc.h> |
| #include <memalign.h> |
| #include <miiphy.h> |
| #include <net.h> |
| #include <netdev.h> |
| #include <phy.h> |
| #include <reset.h> |
| #include <wait_bit.h> |
| #include <asm/arch/clock.h> |
| #include <asm/cache.h> |
| #include <asm/gpio.h> |
| #include <asm/io.h> |
| #include <asm/mach-imx/sys_proto.h> |
| #include <linux/delay.h> |
| |
| #include "dwc_eth_qos.h" |
| |
| __weak u32 imx_get_eqos_csr_clk(void) |
| { |
| return 100 * 1000000; |
| } |
| |
| static ulong eqos_get_tick_clk_rate_imx(struct udevice *dev) |
| { |
| struct eqos_priv *eqos = dev_get_priv(dev); |
| |
| return clk_get_rate(&eqos->clk_master_bus); |
| } |
| |
| static int eqos_probe_resources_imx(struct udevice *dev) |
| { |
| struct eqos_priv *eqos = dev_get_priv(dev); |
| phy_interface_t interface; |
| int ret; |
| |
| debug("%s(dev=%p):\n", __func__, dev); |
| |
| interface = eqos->config->interface(dev); |
| |
| if (interface == PHY_INTERFACE_MODE_NA) { |
| pr_err("Invalid PHY interface\n"); |
| return -EINVAL; |
| } |
| |
| ret = board_interface_eth_init(dev, interface); |
| if (ret) |
| return -EINVAL; |
| |
| eqos->max_speed = dev_read_u32_default(dev, "max-speed", 0); |
| |
| ret = clk_get_by_name(dev, "stmmaceth", &eqos->clk_master_bus); |
| if (ret) { |
| dev_dbg(dev, "clk_get_by_name(master_bus) failed: %d", ret); |
| goto err_probe; |
| } |
| |
| ret = clk_get_by_name(dev, "ptp_ref", &eqos->clk_ptp_ref); |
| if (ret) { |
| dev_dbg(dev, "clk_get_by_name(ptp_ref) failed: %d", ret); |
| goto err_probe; |
| } |
| |
| ret = clk_get_by_name(dev, "tx", &eqos->clk_tx); |
| if (ret) { |
| dev_dbg(dev, "clk_get_by_name(tx) failed: %d", ret); |
| goto err_probe; |
| } |
| |
| ret = clk_get_by_name(dev, "pclk", &eqos->clk_ck); |
| if (ret) { |
| dev_dbg(dev, "clk_get_by_name(pclk) failed: %d", ret); |
| goto err_probe; |
| } |
| |
| debug("%s: OK\n", __func__); |
| return 0; |
| |
| err_probe: |
| |
| debug("%s: returns %d\n", __func__, ret); |
| return ret; |
| } |
| |
| static int eqos_remove_resources_imx(struct udevice *dev) |
| { |
| debug("%s(dev=%p):\n", __func__, dev); |
| return 0; |
| } |
| |
| static int eqos_start_clks_imx(struct udevice *dev) |
| { |
| struct eqos_priv *eqos = dev_get_priv(dev); |
| int ret; |
| |
| debug("%s(dev=%p):\n", __func__, dev); |
| |
| ret = clk_enable(&eqos->clk_master_bus); |
| if (ret < 0) { |
| dev_dbg(dev, "clk_enable(clk_master_bus) failed: %d", ret); |
| goto err; |
| } |
| |
| ret = clk_enable(&eqos->clk_ptp_ref); |
| if (ret < 0) { |
| dev_dbg(dev, "clk_enable(clk_ptp_ref) failed: %d", ret); |
| goto err_disable_clk_master_bus; |
| } |
| |
| ret = clk_enable(&eqos->clk_tx); |
| if (ret < 0) { |
| dev_dbg(dev, "clk_enable(clk_tx) failed: %d", ret); |
| goto err_disable_clk_ptp_ref; |
| } |
| |
| ret = clk_enable(&eqos->clk_ck); |
| if (ret < 0) { |
| dev_dbg(dev, "clk_enable(clk_ck) failed: %d", ret); |
| goto err_disable_clk_tx; |
| } |
| |
| debug("%s: OK\n", __func__); |
| return 0; |
| |
| err_disable_clk_tx: |
| clk_disable(&eqos->clk_tx); |
| err_disable_clk_ptp_ref: |
| clk_disable(&eqos->clk_ptp_ref); |
| err_disable_clk_master_bus: |
| clk_disable(&eqos->clk_master_bus); |
| err: |
| debug("%s: FAILED: %d\n", __func__, ret); |
| return ret; |
| } |
| |
| static int eqos_stop_clks_imx(struct udevice *dev) |
| { |
| struct eqos_priv *eqos = dev_get_priv(dev); |
| |
| debug("%s(dev=%p):\n", __func__, dev); |
| |
| clk_disable(&eqos->clk_ck); |
| clk_disable(&eqos->clk_tx); |
| clk_disable(&eqos->clk_ptp_ref); |
| clk_disable(&eqos->clk_master_bus); |
| |
| debug("%s: OK\n", __func__); |
| return 0; |
| } |
| |
| static int eqos_set_tx_clk_speed_imx(struct udevice *dev) |
| { |
| struct eqos_priv *eqos = dev_get_priv(dev); |
| ulong rate; |
| int ret; |
| |
| if (device_is_compatible(dev, "nxp,imx93-dwmac-eqos")) |
| return 0; |
| |
| debug("%s(dev=%p):\n", __func__, dev); |
| |
| if (eqos->phy->interface == PHY_INTERFACE_MODE_RMII) |
| rate = 5000; /* 5000 kHz = 5 MHz */ |
| else |
| rate = 2500; /* 2500 kHz = 2.5 MHz */ |
| |
| if (eqos->phy->speed == SPEED_1000 && |
| (eqos->phy->interface == PHY_INTERFACE_MODE_RGMII || |
| eqos->phy->interface == PHY_INTERFACE_MODE_RGMII_ID || |
| eqos->phy->interface == PHY_INTERFACE_MODE_RGMII_RXID || |
| eqos->phy->interface == PHY_INTERFACE_MODE_RGMII_TXID)) { |
| rate *= 50; /* Use 50x base rate i.e. 125 MHz */ |
| } else if (eqos->phy->speed == SPEED_100) { |
| rate *= 10; /* Use 10x base rate */ |
| } else if (eqos->phy->speed == SPEED_10) { |
| rate *= 1; /* Use base rate */ |
| } else { |
| pr_err("invalid speed %d", eqos->phy->speed); |
| return -EINVAL; |
| } |
| |
| rate *= 1000; /* clk_set_rate() operates in Hz */ |
| |
| ret = clk_set_rate(&eqos->clk_tx, rate); |
| if (ret < 0) { |
| pr_err("imx (tx_clk, %lu) failed: %d", rate, ret); |
| return ret; |
| } |
| |
| return 0; |
| } |
| |
| static int eqos_get_enetaddr_imx(struct udevice *dev) |
| { |
| struct eth_pdata *pdata = dev_get_plat(dev); |
| |
| imx_get_mac_from_fuse(dev_seq(dev), pdata->enetaddr); |
| |
| return 0; |
| } |
| |
| static struct eqos_ops eqos_imx_ops = { |
| .eqos_inval_desc = eqos_inval_desc_generic, |
| .eqos_flush_desc = eqos_flush_desc_generic, |
| .eqos_inval_buffer = eqos_inval_buffer_generic, |
| .eqos_flush_buffer = eqos_flush_buffer_generic, |
| .eqos_probe_resources = eqos_probe_resources_imx, |
| .eqos_remove_resources = eqos_remove_resources_imx, |
| .eqos_stop_resets = eqos_null_ops, |
| .eqos_start_resets = eqos_null_ops, |
| .eqos_stop_clks = eqos_stop_clks_imx, |
| .eqos_start_clks = eqos_start_clks_imx, |
| .eqos_calibrate_pads = eqos_null_ops, |
| .eqos_disable_calibration = eqos_null_ops, |
| .eqos_set_tx_clk_speed = eqos_set_tx_clk_speed_imx, |
| .eqos_get_enetaddr = eqos_get_enetaddr_imx, |
| .eqos_get_tick_clk_rate = eqos_get_tick_clk_rate_imx, |
| }; |
| |
| struct eqos_config __maybe_unused eqos_imx_config = { |
| .reg_access_always_ok = false, |
| .mdio_wait = 10, |
| .swr_wait = 50, |
| .config_mac = EQOS_MAC_RXQ_CTRL0_RXQ0EN_ENABLED_DCB, |
| .config_mac_mdio = EQOS_MAC_MDIO_ADDRESS_CR_250_300, |
| .axi_bus_width = EQOS_AXI_WIDTH_64, |
| .interface = dev_read_phy_mode, |
| .ops = &eqos_imx_ops |
| }; |