usb: ehci-omap: Remove OMAP_EHCI_PHYx_RESET_GPIO from Kconfig
With the omap-ehci driver now using the phy subsystem to enable
and disable reset, the driver no longer needs to know which
GPIO's are used, and they can be removed from Kconfig.
Signed-off-by: Adam Ford <aford173@gmail.com>
diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig
index f0fb66a..8f77412 100644
--- a/drivers/usb/host/Kconfig
+++ b/drivers/usb/host/Kconfig
@@ -198,40 +198,6 @@
Enables support for the on-chip EHCI controller on OMAP3 and later
SoCs.
-if USB_EHCI_OMAP
-
-config HAS_OMAP_EHCI_PHY1_RESET_GPIO
- bool "PHY #1 requires a GPIO hold to it in RESET while PHY settles"
- help
- Enable this to be able to configure the GPIO number used to hold the
- PHY in RESET for enough time until the PHY is settled and ready.
-
-config OMAP_EHCI_PHY1_RESET_GPIO
- int "GPIO number to hold PHY #1 in RESET"
- depends on HAS_OMAP_EHCI_PHY1_RESET_GPIO
-
-config HAS_OMAP_EHCI_PHY2_RESET_GPIO
- bool "PHY #2 requires a GPIO hold to it in RESET while PHY settles"
- help
- Enable this to be able to configure the GPIO number used to hold the
- PHY in RESET for enough time until the PHY is settled and ready.
-
-config OMAP_EHCI_PHY2_RESET_GPIO
- int "GPIO number to hold PHY #2 in RESET"
- depends on HAS_OMAP_EHCI_PHY2_RESET_GPIO
-
-config HAS_OMAP_EHCI_PHY3_RESET_GPIO
- bool "PHY #3 requires a GPIO hold to it in RESET while PHY settles"
- help
- Enable this to be able to configure the GPIO number used to hold the
- PHY in RESET for enough time until the PHY is settled and ready.
-
-config OMAP_EHCI_PHY3_RESET_GPIO
- int "GPIO number to hold PHY #3 in RESET"
- depends on HAS_OMAP_EHCI_PHY3_RESET_GPIO
-
-endif
-
config USB_EHCI_VF
bool "Support for Vybrid on-chip EHCI USB controller"
depends on ARCH_VF610