NAND fsl elbc: Set FMR[ECCM] based on page size.

Hardware expects ECCM 0 for small page and ECCM 1 for large page
when booting from NAND, so use those defaults.

Signed-off-by: Scott Wood <scottwood@freescale.com>
diff --git a/drivers/mtd/nand/fsl_elbc_nand.c b/drivers/mtd/nand/fsl_elbc_nand.c
index b097ca5..367c7d7 100644
--- a/drivers/mtd/nand/fsl_elbc_nand.c
+++ b/drivers/mtd/nand/fsl_elbc_nand.c
@@ -777,6 +777,20 @@
 	nand->ecc.read_page = fsl_elbc_read_page;
 	nand->ecc.write_page = fsl_elbc_write_page;
 
+#ifdef CONFIG_FSL_ELBC_FMR
+	priv->fmr = CONFIG_FSL_ELBC_FMR;
+#else
+	priv->fmr = (15 << FMR_CWTO_SHIFT) | (2 << FMR_AL_SHIFT);
+
+	/*
+	 * Hardware expects small page has ECCM0, large page has ECCM1
+	 * when booting from NAND.  Board config can override if not
+	 * booting from NAND.
+	 */
+	if (or & OR_FCM_PGS)
+		priv->fmr |= FMR_ECCM;
+#endif
+
 	/* If CS Base Register selects full hardware ECC then use it */
 	if ((br & BR_DECC) == BR_DECC_CHK_GEN) {
 		nand->ecc.mode = NAND_ECC_HW;
@@ -793,8 +807,6 @@
 		nand->ecc.mode = NAND_ECC_SOFT;
 	}
 
-	priv->fmr = (15 << FMR_CWTO_SHIFT) | (2 << FMR_AL_SHIFT);
-
 	/* Large-page-specific setup */
 	if (or & OR_FCM_PGS) {
 		priv->page_size = 1;