Configuration changes for ADS5121 Rev 3
ADS5121 Rev 3 board is now the default config
config targets are now
ads5121_config
Rev 3 board with
PCI
M41T62 on board RTC
512MB DRAM
ads5121_rev2_config
Rev 2 board with
No PCI
256MB DRAM
Signed-off-by: Martha Marx <mmarx@silicontkx.com>
Acked-by: Grant Likely <grant.likely@secretlab.ca>
Acked-by: John Rigby <jrigby@freescale.com>
diff --git a/board/ads5121/ads5121.c b/board/ads5121/ads5121.c
index 130b81d..de59991 100644
--- a/board/ads5121/ads5121.c
+++ b/board/ads5121/ads5121.c
@@ -26,7 +26,9 @@
#include <asm/bitops.h>
#include <command.h>
#include <fdt_support.h>
-
+#ifdef CONFIG_MISC_INIT_R
+#include <i2c.h>
+#endif
/* Clocks in use */
#define SCCR1_CLOCKS_EN (CLOCK_SCCR1_CFG_EN | \
CLOCK_SCCR1_LPC_EN | \
@@ -75,8 +77,21 @@
* Without this the flash identification routine fails, as it needs to issue
* write commands in order to establish the device ID.
*/
- *((volatile u8 *)(CFG_CPLD_BASE + 0x08)) = 0xC1;
+#ifdef CONFIG_ADS5121_REV2
+ *((volatile u8 *)(CFG_CPLD_BASE + 0x08)) = 0xC1;
+#else
+ if (*((u8 *)(CFG_CPLD_BASE + 0x08)) & 0x04) {
+ *((volatile u8 *)(CFG_CPLD_BASE + 0x08)) = 0xC1;
+ } else {
+ /* running from Backup flash */
+ *((volatile u8 *)(CFG_CPLD_BASE + 0x08)) = 0x32;
+ }
+#endif
+ /*
+ * Configure Flash Speed
+ */
+ *((volatile u32 *)(CFG_IMMR + LPC_OFFSET + CS0_CONFIG)) = CFG_CS0_CFG;
/*
* Enable clocks
*/