phylib: Detect link on 10G devices correctly
gen10g_startup() had 2 bugs:
1) It had a boolean logic error in checking the MMD mask, and
always checked all of them.
2) It checked devices which don't actually report link state, which
meant that it would never believe the link was fully up.
Fix the boolean logic, and then mask the MMD mask so only link-reporting
devices are checked.
Signed-off-by: Andy Fleming <afleming@freescale.com>
Reported-by: Ed Swarthout <Ed.Swarthout@freescale.com>
diff --git a/drivers/net/phy/generic_10g.c b/drivers/net/phy/generic_10g.c
index 60dec45..e4a499d 100644
--- a/drivers/net/phy/generic_10g.c
+++ b/drivers/net/phy/generic_10g.c
@@ -36,7 +36,7 @@
int gen10g_startup(struct phy_device *phydev)
{
int devad, reg;
- u32 mmd_mask = phydev->mmds;
+ u32 mmd_mask = phydev->mmds & MDIO_DEVS_LINK;
phydev->link = 1;
@@ -44,8 +44,12 @@
phydev->speed = SPEED_10000;
phydev->duplex = DUPLEX_FULL;
+ /*
+ * Go through all the link-reporting devices, and make sure
+ * they're all up and happy
+ */
for (devad = 0; mmd_mask; devad++, mmd_mask = mmd_mask >> 1) {
- if (!mmd_mask & 1)
+ if (!(mmd_mask & 1))
continue;
/* Read twice because link state is latched and a