ARM: tegra: remove "0, " from DT unit addresses
Apparently the unit address in a DT node name is now supposed to be a
single integer value, rather than a comma-separated list of individual
cell values. Fix the U-Boot DTs to comply with this naming convention.
Signed-off-by: Stephen Warren <swarren@nvidia.com>
Signed-off-by: Tom Warren <twarren@nvidia.com>
diff --git a/arch/arm/dts/tegra210-p2371-2180.dts b/arch/arm/dts/tegra210-p2371-2180.dts
index aa18dd2..0dc06a4 100644
--- a/arch/arm/dts/tegra210-p2371-2180.dts
+++ b/arch/arm/dts/tegra210-p2371-2180.dts
@@ -11,17 +11,17 @@
};
aliases {
- i2c0 = "/i2c@0,7000d000";
- mmc0 = "/sdhci@0,700b0600";
- mmc1 = "/sdhci@0,700b0000";
- usb0 = "/usb@0,7d000000";
+ i2c0 = "/i2c@7000d000";
+ mmc0 = "/sdhci@700b0600";
+ mmc1 = "/sdhci@700b0000";
+ usb0 = "/usb@7d000000";
};
memory {
reg = <0x0 0x80000000 0x0 0xc0000000>;
};
- pcie-controller@0,01003000 {
+ pcie-controller@01003000 {
status = "okay";
pci@1,0 {
@@ -33,7 +33,7 @@
};
};
- padctl@0,7009f000 {
+ padctl@7009f000 {
pinctrl-0 = <&padctl_default>;
pinctrl-names = "default";
@@ -71,7 +71,7 @@
};
};
- sdhci@0,700b0000 {
+ sdhci@700b0000 {
status = "okay";
cd-gpios = <&gpio TEGRA_GPIO(Z, 1) GPIO_ACTIVE_LOW>;
power-gpios = <&gpio TEGRA_GPIO(Z, 3) GPIO_ACTIVE_HIGH>;
@@ -79,18 +79,18 @@
bus-width = <4>;
};
- sdhci@0,700b0600 {
+ sdhci@700b0600 {
status = "okay";
bus-width = <8>;
non-removable;
};
- i2c@0,7000d000 {
+ i2c@7000d000 {
status = "okay";
clock-frequency = <400000>;
};
- usb@0,7d000000 {
+ usb@7d000000 {
status = "okay";
dr_mode = "otg";
nvidia,vbus-gpio = <&gpio TEGRA_GPIO(CC, 4) GPIO_ACTIVE_HIGH>;