TQM85xx: Fix a couple warnings in TQM8548 build
The ecm variable in sdram.c was being declared for all 8548, but only
used by specific 8548 boards, so we make that variable require those
specific boards, too
The nand code was using an index "i" into a table, and then re-using "i"
to set addresses for each upm. However, then it relied on the old value
of i still being there to enable things. Changed the second "i" to "j"
Signed-off-by: Andy Fleming <afleming@freescale.com>
diff --git a/board/tqc/tqm85xx/nand.c b/board/tqc/tqm85xx/nand.c
index dea652d..8133fdc 100644
--- a/board/tqc/tqm85xx/nand.c
+++ b/board/tqc/tqm85xx/nand.c
@@ -395,7 +395,7 @@
*/
static void nand_upm_setup (volatile ccsr_lbc_t *lbc)
{
- uint i;
+ uint i, j;
uint or3 = CONFIG_SYS_OR3_PRELIM;
uint clock = get_lbc_clock ();
@@ -429,8 +429,8 @@
/* Assign address of table */
nand_upm_patt = upm_freq_table[i].upm_patt;
- for (i = 0; i < 64; i++) {
- upmb_write (i, *nand_upm_patt);
+ for (j = 0; j < 64; j++) {
+ upmb_write (j, *nand_upm_patt);
nand_upm_patt++;
}