* Patch by Jon Loeliger, 2005-05-05
Implemented support for MPC8548CDS board.
Added DDR II support based on SPD values for MPC85xx boards.
This roll-up patch also includes bugfies for the previously
published patches:
DDRII CPO, pre eTSEC, 8548 LBIU, Andy's TSEC, eTSEC 3&4 I/O
diff --git a/include/asm-ppc/immap_85xx.h b/include/asm-ppc/immap_85xx.h
index e9bb989..22f19f0 100644
--- a/include/asm-ppc/immap_85xx.h
+++ b/include/asm-ppc/immap_85xx.h
@@ -81,21 +81,27 @@
uint cs1_config; /* 0x2084 - DDR Chip Select Configuration */
uint cs2_config; /* 0x2088 - DDR Chip Select Configuration */
uint cs3_config; /* 0x208c - DDR Chip Select Configuration */
- char res5[120];
+ char res5[112];
+ uint ext_refrec; /* 0x2100 - DDR SDRAM Extended Refresh Recovery */
+ uint timing_cfg_0; /* 0x2104 - DDR SDRAM Timing Configuration Register 0 */
uint timing_cfg_1; /* 0x2108 - DDR SDRAM Timing Configuration Register 1 */
uint timing_cfg_2; /* 0x210c - DDR SDRAM Timing Configuration Register 2 */
uint sdram_cfg; /* 0x2110 - DDR SDRAM Control Configuration */
- char res6[4];
+ uint sdram_cfg_2; /* 0x2114 - DDR SDRAM Control Configuration 2 */
uint sdram_mode; /* 0x2118 - DDR SDRAM Mode Configuration */
- char res7[8];
+ uint sdram_mode_2; /* 0x211c - DDR SDRAM Mode Configuration 2*/
+ uint sdram_md_cntl; /* 0x2120 - DDR SDRAM Mode Control */
uint sdram_interval; /* 0x2124 - DDR SDRAM Interval Configuration */
-#ifdef MPC85xx_DDR_SDRAM_CLK_CNTL
- char res7_5[8];
+ uint sdram_data_init; /* 0x2128 - DDR SDRAM Data initialization */
+ char res6[4];
uint sdram_clk_cntl; /* 0x2130 - DDR SDRAM Clock Control */
- char res8[3276];
-#else
- char res8[3288];
-#endif
+ char res7[20];
+ uint init_address; /* 0x2148 - DDR training initialization address */
+ uint init_ext_address; /* 0x214C - DDR training initialization extended address */
+ char res8_1[2728];
+ uint ip_rev1; /* 0x2BF8 - DDR IP Block Revision 1 */
+ uint ip_rev2; /* 0x2BFC - DDR IP Block Revision 2 */
+ char res8_2[512];
uint data_err_inject_hi; /* 0x2e00 - DDR Memory Data Path Error Injection Mask High */
uint data_err_inject_lo; /* 0x2e04 - DDR Memory Data Path Error Injection Mask Low */
uint ecc_err_inject; /* 0x2e08 - DDR Memory Data Path Error Injection Mask ECC */
@@ -120,6 +126,8 @@
} ccsr_ddr_t;
+
+
/* I2C Registers(0x3000-0x4000) */
typedef struct ccsr_i2c {
@@ -158,6 +166,7 @@
#if defined(CONFIG_MPC8540) \
|| defined(CONFIG_MPC8541) \
+ || defined(CONFIG_MPC8548) \
|| defined(CONFIG_MPC8555)
/* DUART Registers(0x4000-0x5000) */
typedef struct ccsr_duart {
@@ -1547,7 +1556,13 @@
uint ddrdllcr; /* 0xe0e10 - DDR DLL control register */
char res12[12];
uint lbcdllcr; /* 0xe0e20 - LBC DLL control register */
- char res13[61915];
+ char res13[248];
+ uint lbiuiplldcr0; /* 0xe0f1c -- LBIU PLL Debug Reg 0 */
+ uint lbiuiplldcr1; /* 0xe0f20 -- LBIU PLL Debug Reg 1 */
+ uint ddrioovcr; /* 0xe0f24 - DDR IO Override Control */
+ uint res14; /* 0xe0f28 */
+ uint tsec34ioovcr; /* 0xe0f2c - eTSEC 3/4 IO override control */
+ char res15[61651];
} ccsr_gur_t;
typedef struct immap {
diff --git a/include/asm-ppc/processor.h b/include/asm-ppc/processor.h
index 71fadbc..20949dc 100644
--- a/include/asm-ppc/processor.h
+++ b/include/asm-ppc/processor.h
@@ -420,6 +420,7 @@
#define SPRN_MAS4 0x274 /* MMU Assist Register 4 */
#define SPRN_MAS5 0x275 /* MMU Assist Register 5 */
#define SPRN_MAS6 0x276 /* MMU Assist Register 6 */
+#define SPRN_MAS7 0x3B0 /* MMU Assist Register 7 */
#define SPRN_IVOR32 0x210 /* Interrupt Vector Offset Register 32 */
#define SPRN_IVOR33 0x211 /* Interrupt Vector Offset Register 33 */
@@ -584,6 +585,7 @@
#define MAS4 SPRN_MAS4
#define MAS5 SPRN_MAS5
#define MAS6 SPRN_MAS6
+#define MAS7 SPRN_MAS7
/* Device Control Registers */
@@ -792,6 +794,8 @@
#define SVR_8560 0x8070
#define SVR_8555 0x8079
#define SVR_8541 0x807A
+#define SVR_8548 0x8031
+#define SVR_8548_E 0x8039
/* I am just adding a single entry for 8260 boards. I think we may be