powerpc/mpc8xxx: Set inactive csn_bnds to 0xffffffff
When chip select interleaving is enabled, cs0_bnds is used for address
binding. Other csn_bnds are not used. When two controllers interleaving is
enabled, cs0_bnds of both controllers are used, other csn_bnds are not.
However, the unused csn_bnds may be used internally for calculating
addresses for calibration. Setting those registers to 0 may confuse
controllers in some cases. Instead, setting them to 0xffffffff together
with normal LAWs will guarantee the address is not mapped to DDR.
Signed-off-by: York Sun <yorksun@freescale.com>
diff --git a/arch/powerpc/cpu/mpc8xxx/ddr/ctrl_regs.c b/arch/powerpc/cpu/mpc8xxx/ddr/ctrl_regs.c
index 0f73e9c..b5e4070 100644
--- a/arch/powerpc/cpu/mpc8xxx/ddr/ctrl_regs.c
+++ b/arch/powerpc/cpu/mpc8xxx/ddr/ctrl_regs.c
@@ -1585,8 +1585,8 @@
| ((ea & 0xFFF) << 0) /* ending address MSB */
);
} else {
- debug("FSLDDR: setting bnds to 0 for inactive CS\n");
- ddr->cs[i].bnds = 0;
+ /* setting bnds to 0xffffffff for inactive CS */
+ ddr->cs[i].bnds = 0xffffffff;
}
debug("FSLDDR: cs[%d]_bnds = 0x%08x\n", i, ddr->cs[i].bnds);
diff --git a/arch/powerpc/cpu/mpc8xxx/ddr/main.c b/arch/powerpc/cpu/mpc8xxx/ddr/main.c
index 7a8636d..c35405d 100644
--- a/arch/powerpc/cpu/mpc8xxx/ddr/main.c
+++ b/arch/powerpc/cpu/mpc8xxx/ddr/main.c
@@ -504,7 +504,13 @@
fsl_ddr_cfg_regs_t *reg = &ddr_reg[i];
if (reg->cs[j].config & 0x80000000) {
unsigned int end;
- end = reg->cs[j].bnds & 0xFFF;
+ /*
+ * 0xfffffff is a special value we put
+ * for unused bnds
+ */
+ if (reg->cs[j].bnds == 0xffffffff)
+ continue;
+ end = reg->cs[j].bnds & 0xffff;
if (end > max_end) {
max_end = end;
}