arm: omap: add support for am57xx devices
just add a few ifdefs around because this
device is very similar to dra7xxx.
Signed-off-by: Felipe Balbi <balbi@ti.com>
Reviewed-by: Tom Rini <trini@ti.com>
diff --git a/drivers/mmc/omap_hsmmc.c b/drivers/mmc/omap_hsmmc.c
index ffb5284..bada006 100644
--- a/drivers/mmc/omap_hsmmc.c
+++ b/drivers/mmc/omap_hsmmc.c
@@ -663,7 +663,8 @@
case 1:
priv_data->base_addr = (struct hsmmc *)OMAP_HSMMC2_BASE;
#if (defined(CONFIG_OMAP44XX) || defined(CONFIG_OMAP54XX) || \
- defined(CONFIG_DRA7XX)) && defined(CONFIG_HSMMC2_8BIT)
+ defined(CONFIG_DRA7XX) || defined(CONFIG_AM57XX)) && \
+ defined(CONFIG_HSMMC2_8BIT)
/* Enable 8-bit interface for eMMC on OMAP4/5 or DRA7XX */
host_caps_val |= MMC_MODE_8BIT;
#endif
@@ -672,7 +673,7 @@
#ifdef OMAP_HSMMC3_BASE
case 2:
priv_data->base_addr = (struct hsmmc *)OMAP_HSMMC3_BASE;
-#if defined(CONFIG_DRA7XX) && defined(CONFIG_HSMMC3_8BIT)
+#if (defined(CONFIG_DRA7XX) || defined(CONFIG_AM57XX)) && defined(CONFIG_HSMMC3_8BIT)
/* Enable 8-bit interface for eMMC on DRA7XX */
host_caps_val |= MMC_MODE_8BIT;
#endif