diff --git a/arch/arm/dts/sun50i-h6-beelink-gs1.dts b/arch/arm/dts/sun50i-h6-beelink-gs1.dts
index 54b0882..0dc33c9 100644
--- a/arch/arm/dts/sun50i-h6-beelink-gs1.dts
+++ b/arch/arm/dts/sun50i-h6-beelink-gs1.dts
@@ -14,6 +14,7 @@
 	compatible = "azw,beelink-gs1", "allwinner,sun50i-h6";
 
 	aliases {
+		ethernet0 = &emac;
 		serial0 = &uart0;
 	};
 
@@ -21,6 +22,17 @@
 		stdout-path = "serial0:115200n8";
 	};
 
+	connector {
+		compatible = "hdmi-connector";
+		type = "a";
+
+		port {
+			hdmi_con_in: endpoint {
+				remote-endpoint = <&hdmi_out_con>;
+			};
+		};
+	};
+
 	leds {
 		compatible = "gpio-leds";
 
@@ -41,6 +53,40 @@
 	};
 };
 
+&de {
+	status = "okay";
+};
+
+&ehci0 {
+	status = "okay";
+};
+
+&emac {
+	pinctrl-names = "default";
+	pinctrl-0 = <&ext_rgmii_pins>;
+	phy-mode = "rgmii";
+	phy-handle = <&ext_rgmii_phy>;
+	phy-supply = <&reg_aldo2>;
+	status = "okay";
+};
+
+&hdmi {
+	status = "okay";
+};
+
+&hdmi_out {
+	hdmi_out_con: endpoint {
+		remote-endpoint = <&hdmi_con_in>;
+	};
+};
+
+&mdio {
+	ext_rgmii_phy: ethernet-phy@1 {
+		compatible = "ethernet-phy-ieee802.3-c22";
+		reg = <1>;
+	};
+};
+
 &mmc0 {
 	vmmc-supply = <&reg_cldo1>;
 	cd-gpios = <&pio 5 6 GPIO_ACTIVE_LOW>;
@@ -57,6 +103,15 @@
 	status = "okay";
 };
 
+&ohci0 {
+	status = "okay";
+};
+
+&pio {
+	vcc-pd-supply = <&reg_cldo1>;
+	vcc-pg-supply = <&reg_aldo1>;
+};
+
 &r_i2c {
 	status = "okay";
 
@@ -177,8 +232,29 @@
 	};
 };
 
+&r_pio {
+	/*
+	 * PL0 and PL1 are used for PMIC I2C
+	 * don't enable the pl-supply else
+	 * it will fail at boot
+	 *
+	 * vcc-pl-supply = <&reg_aldo1>;
+	 */
+	vcc-pm-supply = <&reg_aldo1>;
+};
+
 &uart0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&uart0_ph_pins>;
 	status = "okay";
 };
+
+&usb2otg {
+	dr_mode = "host";
+	status = "okay";
+};
+
+&usb2phy {
+	usb0_vbus-supply = <&reg_vcc5v>;
+	status = "okay";
+};
diff --git a/arch/arm/dts/sun50i-h6-pine-h64.dts b/arch/arm/dts/sun50i-h6-pine-h64.dts
index 4802902..1898345 100644
--- a/arch/arm/dts/sun50i-h6-pine-h64.dts
+++ b/arch/arm/dts/sun50i-h6-pine-h64.dts
@@ -127,6 +127,12 @@
 	status = "okay";
 };
 
+&pio {
+	vcc-pc-supply = <&reg_bldo2>;
+	vcc-pd-supply = <&reg_cldo1>;
+	vcc-pg-supply = <&reg_aldo1>;
+};
+
 &r_i2c {
 	status = "okay";
 
@@ -243,10 +249,16 @@
 	pcf8563: rtc@51 {
 		compatible = "nxp,pcf8563";
 		reg = <0x51>;
+		interrupt-parent = <&r_intc>;
+		interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
 		#clock-cells = <0>;
 	};
 };
 
+&r_pio {
+	vcc-pm-supply = <&reg_aldo1>;
+};
+
 &uart0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&uart0_ph_pins>;
diff --git a/arch/arm/dts/sun50i-h6.dtsi b/arch/arm/dts/sun50i-h6.dtsi
index e0dc4a0..a117f47 100644
--- a/arch/arm/dts/sun50i-h6.dtsi
+++ b/arch/arm/dts/sun50i-h6.dtsi
@@ -101,7 +101,7 @@
 		#size-cells = <1>;
 		ranges;
 
-		display-engine@1000000 {
+		bus@1000000 {
 			compatible = "allwinner,sun50i-h6-de3",
 				     "allwinner,sun50i-a64-de2";
 			reg = <0x1000000 0x400000>;
@@ -203,11 +203,32 @@
 			#reset-cells = <1>;
 		};
 
+		dma: dma-controller@3002000 {
+			compatible = "allwinner,sun50i-h6-dma";
+			reg = <0x03002000 0x1000>;
+			interrupts = <GIC_SPI 43 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&ccu CLK_BUS_DMA>, <&ccu CLK_MBUS_DMA>;
+			clock-names = "bus", "mbus";
+			dma-channels = <16>;
+			dma-requests = <46>;
+			resets = <&ccu RST_BUS_DMA>;
+			#dma-cells = <1>;
+		};
+
 		sid: sid@3006000 {
 			compatible = "allwinner,sun50i-h6-sid";
 			reg = <0x03006000 0x400>;
 		};
 
+		watchdog: watchdog@30090a0 {
+			compatible = "allwinner,sun50i-h6-wdt",
+				     "allwinner,sun6i-a31-wdt";
+			reg = <0x030090a0 0x20>;
+			interrupts = <GIC_SPI 50 IRQ_TYPE_LEVEL_HIGH>;
+			/* Broken on some H6 boards */
+			status = "disabled";
+		};
+
 		pio: pinctrl@300b000 {
 			compatible = "allwinner,sun50i-h6-pinctrl";
 			reg = <0x0300b000 0x400>;
@@ -243,6 +264,18 @@
 				bias-pull-up;
 			};
 
+			/*
+			 * /omit-if-no-ref/ isn't supported by U-boot
+			 * keep this comment to avoid bad sync with Linux
+			 */
+			mmc1_pins: mmc1-pins {
+				pins = "PG0", "PG1", "PG2", "PG3",
+				       "PG4", "PG5";
+				function = "mmc1";
+				drive-strength = <30>;
+				bias-pull-up;
+			};
+
 			mmc2_pins: mmc2-pins {
 				pins = "PC1", "PC4", "PC5", "PC6",
 				       "PC7", "PC8", "PC9", "PC10",
@@ -294,6 +327,8 @@
 			resets = <&ccu RST_BUS_MMC1>;
 			reset-names = "ahb";
 			interrupts = <GIC_SPI 36 IRQ_TYPE_LEVEL_HIGH>;
+			pinctrl-names = "default";
+			pinctrl-0 = <&mmc1_pins>;
 			status = "disabled";
 			#address-cells = <1>;
 			#size-cells = <0>;
@@ -445,7 +480,6 @@
 			resets = <&ccu RST_BUS_OHCI3>,
 				 <&ccu RST_BUS_EHCI3>;
 			phys = <&usb2phy 3>;
-			phy-names = "usb";
 			status = "disabled";
 		};
 
@@ -457,7 +491,6 @@
 				 <&ccu CLK_USB_OHCI3>;
 			resets = <&ccu RST_BUS_OHCI3>;
 			phys = <&usb2phy 3>;
-			phy-names = "usb";
 			status = "disabled";
 		};
 
@@ -613,6 +646,13 @@
 			#reset-cells = <1>;
 		};
 
+		r_watchdog: watchdog@7020400 {
+			compatible = "allwinner,sun50i-h6-wdt",
+				     "allwinner,sun6i-a31-wdt";
+			reg = <0x07020400 0x20>;
+			interrupts = <GIC_SPI 103 IRQ_TYPE_LEVEL_HIGH>;
+		};
+
 		r_intc: interrupt-controller@7021000 {
 			compatible = "allwinner,sun50i-h6-r-intc",
 				     "allwinner,sun6i-a31-r-intc";