Patches by Stephan Linz, 11 Dec 2003:
- more documentation for NIOS port
- new struct nios_pio_t, struct nios_spi_t
- Reconfiguration for NIOS Development Kit DK1C20:
o move board related code from board/dk1c20
to board/altera/dk1c20
o create a new common source path board/altera/common
and move generic flash access stuff into it
o change/expand configuration file DK1C20.h
- Add support for NIOS Development Kit DK1S10
- Add status LED support for NIOS systems
- Add dual 7-segment LED support for Altera NIOS DevKits
diff --git a/doc/README.nios_DK b/doc/README.nios_DK
new file mode 100644
index 0000000..b119d76
--- /dev/null
+++ b/doc/README.nios_DK
@@ -0,0 +1,192 @@
+
+===============================================================================
+ H A R D W A R E O V E R V I E W
+===============================================================================
+===============|===============|===============|===============|===============
+ | DK20K200 | DK1C20 | DK1S10 | DK1S40
+---------------|---------------|---------------|---------------|---------------
+ | | | |
+ Schem. Nr. | Nios Dev.Brd. | P06-08713-00 | P06-08468-01 | P06-09178-00
+ Rev. | pilot. | 01 | 01 | 00
+ Date | 2001/02/06 | 2003/02/20 | 2003/02/14 | 2003/05/14
+[1] | | | |
+===============|===============|===============|===============|===============
+ | | | |
+ FPGA | "APEX" | "Cyclon" | "Stratix" | "Stratix"
+ | EP20K200E | EP1C20 | EP1S10 | EP1S40
+ | | |
+ | (484 FBGA) | (400 FBGA) | (780 FBGA)
+[2],[3],[4] | | |
+---------------|---------------|---------------|---------------|---------------
+ | |
+ Clock (OSC) | 33.333 MHz | 50 MHz
+ | | (with ext. supply)
+ |
+ | PI49FCT3805
+[5] |
+---------------|---------------|---------------|---------------|---------------
+ | |
+ Flash | 1 MByte | 8 MByte
+ | |
+ | AM29LV800BB | AM29LV065DU120REI
+ | 8/16 bit bus | 8 bit bus
+ | 1 chip | 1 chip
+[6],[7] | |
+---------------|---------------|---------------|---------------|---------------
+ | | |
+ serial | no such | 4 MBits | no such
+ Flash | | |
+ | | EPCS4SI8 |
+[8] | | |
+---------------|---------------|---------------|---------------|---------------
+ | |
+ Compact | no such, as | see below: prototype adapter
+ Flash (CF) | module only |
+ | |
+---------------|---------------|---------------|---------------|---------------
+ | |
+ SRAM | 256 KByte | 1 MByte
+ | |
+ | IDT71V016S | IDT71V416S10PH
+ | 32 bit bus | 32 bit bus
+ | 2 chips | 2 chips
+ | interlaced | interlaced
+[9],[10] | |
+---------------|---------------|---------------|---------------|---------------
+ | |
+ SDRAM | SODIMM only | 16 MByte
+ | |
+ | | MT48LC4M32B2TG-7
+ | 64 bit bus | 32 bit bus
+ | | 1 chip
+[11] | |
+===============|===============|===============|===============|===============
+ | |
+ serial I/O | 1 RS232 | 2 RS232
+ | |
+ | LTC1386 | MAX3237CAI
+ | |
+ | port 1: | port 1:
+ | RxD / TxD, | RxD / TxD,
+ | RTS / CTS | RTS / CTS, DTR / DSR, DCD, RI
+ | |
+ | ! ! ! ! ! ! | port 2: | port 2:
+ | RTS/CTS can | RxD / TxD | RxD / TxD
+ | be RxD/TxD | | RTS / CTS, DTR / DSR
+ | of 2nd port | | DCD, RI
+[12],[13] | ! ! ! ! ! ! | |
+---------------|---------------|---------------|---------------|---------------
+ | |
+ Ethernet | no such, as | 1 10BaseT / 100BaseT
+ | module only |
+ | | LAN91C111-NE
+ | | 32 bit bus
+ | | no external EEPROM
+ | | LEDA# for link
+ | | LEDB# for Rx / Tx
+[14] | |
+===============|===============|===============|===============|===============
+ | |
+ user | 8 | no such
+ switches | SW[7..0] |
+ | |
+---------------|---------------|---------------|---------------|---------------
+ |
+ user push | 4
+ buttons | PB[3..0]
+ |
+---------------|---------------|---------------|---------------|---------------
+ | |
+ user LEDs | 2 | 8
+ | LED[1..0] | LED[7..0]
+ | |
+---------------|---------------|---------------|---------------|---------------
+ |
+ user seven | 2
+ segment | HEX[1..0][G..A,DP]
+ |
+===============|===============|===============|===============|===============
+ | |
+ 3.3V proto- | w/o level | no such -- only 5V
+ type adapter | shift buffer |
+ | |
+ | 40 I/O pins |
+ | 1 card sel. |
+ | 1 reset out. |
+ | 1 OSC clock |
+ | 1 CPU clock |
+ | 1 clock out. |
+ | |
+---------------|---------------|---------------|---------------|---------------
+ | |
+ 5V prototype | with level | 2 ports -- both card ports supplied with its
+ adapter | shift buffer | own level shift buffer
+ | |
+ | 40 I/O pins | port 1 & 2:
+ | 1 card sel. | 41 I/O pins
+ | 1 Vee ? ? ? | 1 card select
+ | 1 reset out. | 1 reset output (from dev/board)
+ | 1 OSC clock | 1 OSC clock (from dev/board)
+ | 1 CPU clock | 1 CPU clock (from dev/board)
+ | 1 clock inp. | 1 clock input (to dev/board)
+ | |
+ | | (special) port 1:
+ | | 1 CF select
+ | | 1 CF present
+ | | 1 CF ATA select
+ | | 1 CF power
+ | |
+ | | NOTE: Both card ports are prepared for raw
+ | | IDE working. You can connect such
+ | | devices directly to the 40 pin header.
+ | | The signal PDIAG (passed diagnostic)
+ | | is not connected to any I/O signal.
+ | | Card port 1 is hard wired to the on
+ | | board Copact Flash adapter together
+ | | with all other signals needed by CF
+ | | cards. Hot plug should be working too.
+[15],[16] | |
+===============|===============|===============|===============|===============
+ | |
+ config. CPLD | EPM7064 | EPM7128
+ | |
+ (alternative | decition by | decision by
+ FPGA conf.) | jumper | push button
+ | |
+ | FPGA config. | FPGA config. | FPGA config.
+ | from Flash | from Flash | from Flash
+ | only | and EPCS4 | only
+ | | |
+===============|===============|===============|===============|===============
+===============================================================================
+
+
+===============================================================================
+ R E F E R E N C E S
+===============================================================================
+[1] http://www.altera.com/literature/lit-nio.jsp
+[2] http://www.altera.com/literature/lit-apx.jsp
+[3] http://www.altera.com/literature/lit-cyc.jsp
+[4] http://www.altera.com/literature/lit-stx.jsp
+[5] http://www.pericom.com/pdf/datasheets/PI49FCT3805.pdf
+ http://www.pericom.com/products/clock/psempart.php?productID=PI49FCT3805
+[6] http://www.amd.com/us-en/FlashMemory/ProductInformation/0,,37_1447_1623_1468^1532,00.html
+ http://www.amd.com/us-en/assets/content_type/white_papers_and_tech_docs/21490.pdf
+[7] http://www.amd.com/us-en/FlashMemory/ProductInformation/0,,37_1447_1623_1468^1596,00.html
+ http://www.amd.com/us-en/assets/content_type/white_papers_and_tech_docs/23544b.pdf
+[8] http://www.altera.com/literature/lit-config.html
+ http://preview.altera.com/literature/ds/micron.pdf
+[9] http://www.idt.com/products/pages/Asynchronous_SRAMs-71V016SA.html
+[10] http://www.idt.com/products/pages/Asynchronous_SRAMs-71V416SL.html
+[11] http://www.micron.com/products/dram/sdram/part.aspx?part=MT48LC4M32B2TG-7
+[12] http://www.linear.com/prod/datasheet.html?datasheet=33
+ http://www.linear.com/pdf/1386fa.pdf
+[13] http://www.maxim-ic.com/quick_view2.cfm/qv_pk/1068/ln/en
+ http://pdfserv.maxim-ic.com/en/ds/MAX3222-MAX3241.pdf
+[14] http://www.smsc.com/main/catalog/lan91c111.html
+[15] http://www.t13.org/index.html
+[16] http://www.compactflash.org/faqs/faq.htm
+
+
+===============================================================================
+Stephan Linz <linz@li-pro.net>