armv8: fsl-layerscape: Make DDR non secure in MMU tables
DDR has been set as secure in MMU tables. Non-secure master such
as SDHC DMA cannot access data correctly. Mixing secure and non-
secure MMU entries requirs the MMU tables themselves in secure
memory. This patch moves MMU tables into a secure DDR area.
Early MMU tables are changed to set DDR as non-secure. A new
table is added into final MMU tables so secure memory can have
2MB granuality.
gd->secure_ram tracks the location of this secure memory. For
ARMv8 SoCs, the RAM base is not zero and RAM is divided into several
banks. gd->secure_ram needs to be maintained before using. This
maintenance is board-specific, depending on the SoC and memory
bank of the secure memory falls into.
Signed-off-by: York Sun <yorksun@freescale.com>
diff --git a/board/freescale/ls2080ardb/ddr.c b/board/freescale/ls2080ardb/ddr.c
index 76f3b59..6c19173 100644
--- a/board/freescale/ls2080ardb/ddr.c
+++ b/board/freescale/ls2080ardb/ddr.c
@@ -175,14 +175,29 @@
phys_size_t dp_ddr_size;
#endif
+ /*
+ * gd->secure_ram tracks the location of secure memory.
+ * It was set as if the memory starts from 0.
+ * The address needs to add the offset of its bank.
+ */
gd->bd->bi_dram[0].start = CONFIG_SYS_SDRAM_BASE;
if (gd->ram_size > CONFIG_SYS_LS2_DDR_BLOCK1_SIZE) {
gd->bd->bi_dram[0].size = CONFIG_SYS_LS2_DDR_BLOCK1_SIZE;
gd->bd->bi_dram[1].start = CONFIG_SYS_DDR_BLOCK2_BASE;
gd->bd->bi_dram[1].size = gd->ram_size -
CONFIG_SYS_LS2_DDR_BLOCK1_SIZE;
+#ifdef CONFIG_SYS_MEM_RESERVE_SECURE
+ gd->secure_ram = gd->bd->bi_dram[1].start +
+ gd->secure_ram -
+ CONFIG_SYS_LS2_DDR_BLOCK1_SIZE;
+ gd->secure_ram |= MEM_RESERVE_SECURE_MAINTAINED;
+#endif
} else {
gd->bd->bi_dram[0].size = gd->ram_size;
+#ifdef CONFIG_SYS_MEM_RESERVE_SECURE
+ gd->secure_ram = gd->bd->bi_dram[0].start + gd->secure_ram;
+ gd->secure_ram |= MEM_RESERVE_SECURE_MAINTAINED;
+#endif
}
#ifdef CONFIG_SYS_DP_DDR_BASE_PHY