Migrate esd 405EP boards to new NAND subsystem
Migrate esd 405EP boards to new NAND subsystem
-cleanup
-use correct io accessors (in/out_be32())
Signed-off-by: Matthias Fuchs <matthias.fuchs@esd-electronics.com>
diff --git a/board/esd/hh405/hh405.c b/board/esd/hh405/hh405.c
index ea344c0..67b5d54 100644
--- a/board/esd/hh405/hh405.c
+++ b/board/esd/hh405/hh405.c
@@ -5,7 +5,7 @@
* (C) Copyright 2005
* Stefan Roese, DENX Software Engineering, sr@denx.de.
*
- * (C) Copyright 2006
+ * (C) Copyright 2006-2007
* Matthias Fuchs, esd GmbH, matthias.fuchs@esd-electronics.com
*
* See file CREDITS for list of people who contributed to this
@@ -477,12 +477,6 @@
out32(GPIO0_OR, in32(GPIO0_OR) | CFG_EEPROM_WP);
/*
- * Set NAND-FLASH GPIO signals to default
- */
- out32(GPIO0_OR, in32(GPIO0_OR) & ~(CFG_NAND_CLE | CFG_NAND_ALE));
- out32(GPIO0_OR, in32(GPIO0_OR) | CFG_NAND_CE);
-
- /*
* Reset touch-screen controller
*/
out32(GPIO0_OR, in32(GPIO0_OR) & ~CFG_TOUCH_RST);
@@ -690,20 +684,6 @@
#endif /* CONFIG_IDE_RESET */
-#if (CONFIG_COMMANDS & CFG_CMD_NAND)
-#include <linux/mtd/nand_legacy.h>
-extern struct nand_chip nand_dev_desc[CFG_MAX_NAND_DEVICE];
-
-void nand_init(void)
-{
- nand_probe(CFG_NAND_BASE);
- if (nand_dev_desc[0].ChipID != NAND_ChipID_UNKNOWN) {
- print_size(nand_dev_desc[0].totlen, "\n");
- }
-}
-#endif
-
-
#if defined(CFG_EEPROM_WREN)
/* Input: <dev_addr> I2C address of EEPROM device to enable.
* <state> -1: deliver current state