powerpc/p2041rdb: update cpld reset command according to CPLD 2.0

CPLD 2.0 provides a new register which bit[0] is set to '1' will reset
board with initializing the CPLD registers to default values. And add
bit[6] of register at offset 0x5 to use to enable flash bank selection.

Signed-off-by: Shaohui Xie <Shaohui.Xie@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/board/freescale/p2041rdb/cpld.c b/board/freescale/p2041rdb/cpld.c
index 8e1f46e..37b0ed5 100644
--- a/board/freescale/p2041rdb/cpld.c
+++ b/board/freescale/p2041rdb/cpld.c
@@ -53,7 +53,11 @@
  */
 void __cpld_set_altbank(void)
 {
+	u8 reg5 = CPLD_READ(sw_ctl_on);
+
+	CPLD_WRITE(sw_ctl_on, reg5 | CPLD_SWITCH_BANK_ENABLE);
 	CPLD_WRITE(fbank_sel, 1);
+	CPLD_WRITE(system_rst, 1);
 }
 void cpld_set_altbank(void)
 	__attribute__((weak, alias("__cpld_set_altbank")));
@@ -61,12 +65,12 @@
 /**
  * Set the boot bank to the default bank
  */
-void __cpld_clear_altbank(void)
+void __cpld_set_defbank(void)
 {
-	CPLD_WRITE(fbank_sel, 0);
+	CPLD_WRITE(system_rst_default, 1);
 }
-void cpld_clear_altbank(void)
-	__attribute__((weak, alias("__cpld_clear_altbank")));
+void cpld_set_defbank(void)
+	__attribute__((weak, alias("__cpld_set_defbank")));
 
 #ifdef DEBUG
 static void cpld_dump_regs(void)
@@ -101,9 +105,7 @@
 		if (strcmp(argv[2], "altbank") == 0)
 			cpld_set_altbank();
 		else
-			cpld_clear_altbank();
-
-		cpld_reset();
+			cpld_set_defbank();
 	} else if (strcmp(argv[1], "watchdog") == 0) {
 		static char *period[8] = {"1ms", "10ms", "30ms", "disable",
 			"100ms", "1s", "10s", "60s"};