ColdFire: Use CFI Flash driver for M54455EVB
Remove non-common flash driver in
board/freescale/m54455evb/flash.c. The non-cfi flash will
use CONFIG_FLASH_CFI_LEGACY to configure the flash
attribute.
Signed-off-by: TsiChung Liew <Tsi-Chung.Liew@freescale.com>
diff --git a/include/configs/M54455EVB.h b/include/configs/M54455EVB.h
index 6620f03..6f93eea 100644
--- a/include/configs/M54455EVB.h
+++ b/include/configs/M54455EVB.h
@@ -297,9 +297,7 @@
# define CFG_ENV_SECT_SIZE 0x20000
#endif
-/* M54455EVB has one non CFI flash, defined CFG_FLASH_CFI will cause the system
- keep reset. */
-#undef CFG_FLASH_CFI
+#define CFG_FLASH_CFI
#ifdef CFG_FLASH_CFI
# define CONFIG_FLASH_CFI_DRIVER 1
@@ -310,49 +308,18 @@
# define CFG_FLASH_PROTECTION /* "Real" (hardware) sectors protection */
# define CFG_FLASH_CHECKSUM
# define CFG_FLASH_BANKS_LIST { CFG_CS0_BASE, CFG_CS1_BASE }
+# define CONFIG_FLASH_CFI_LEGACY
-#else
-
-# define CFG_MAX_FLASH_BANKS 3 /* max number of memory banks */
-
+#ifdef CONFIG_FLASH_CFI_LEGACY
# define CFG_ATMEL_REGION 4
# define CFG_ATMEL_TOTALSECT 11
# define CFG_ATMEL_SECT {1, 2, 1, 7}
# define CFG_ATMEL_SECTSZ {0x4000, 0x2000, 0x8000, 0x10000}
-# define CFG_INTEL_SECT 137
-
-/* max number of sectors on one chip */
-# define CFG_MAX_FLASH_SECT (CFG_ATMEL_TOTALSECT + CFG_INTEL_SECT)
-# define CFG_FLASH_ERASE_TOUT 2000 /* Atmel needs longer timeout */
-# define CFG_FLASH_WRITE_TOUT 500 /* Flash Write Timeout (in ms) */
-# define CFG_FLASH_LOCK_TOUT 5 /* Timeout for Flash Set Lock Bit (in ms) */
-# define CFG_FLASH_UNLOCK_TOUT 100 /* Timeout for Flash Clear Lock Bits (in ms) */
-# define CFG_FLASH_PROTECTION /* "Real" (hardware) sectors protection */
-# define CFG_FLASH_CHECKSUM
-
-#ifdef CONFIG_SERIAL_FLASH
-# define CFG_FLASH2_BASE 0x01000000
-# define CFG_STM_SECT 32
-# define CFG_STM_SECTSZ 0x10000
-
-# undef CFG_FLASH_ERASE_TOUT
-# define CFG_FLASH_ERASE_TOUT 20000
-
-# define SER_WREN 0x06
-# define SER_WRDI 0x04
-# define SER_RDID 0x9F
-# define SER_RDSR 0x05
-# define SER_WRSR 0x01
-# define SER_READ 0x03
-# define SER_F_READ 0x0B
-# define SER_PAGE_PROG 0x02
-# define SER_SECT_ERASE 0xD8
-# define SER_BULK_ERASE 0xC7
-# define SER_DEEP_PWRDN 0xB9
-# define SER_RES 0xAB
+#endif
#endif
-#endif
+#define CFG_FLASH_PROTECTION /* "Real" (hardware) sectors protection */
+#define CFG_FLASH_CHECKSUM
/*
* This is setting for JFFS2 support in u-boot.