arm, at91: small updates for the smartweb board
- add CONFIG_BOOT_RETRY_TIME to 30
- fex LED colors
- fix button pressed combination
- add
CONFIG_USB_HOST_ETHER
CONFIG_USB_ETHER_ASIX
CONFIG_USB_ETHER_MCS7830
Signed-off-by: Heiko Schocher <hs@denx.de>
Signed-off-by: Matthias Michel <matthias.michel@siemens.com>
diff --git a/board/siemens/smartweb/smartweb.c b/board/siemens/smartweb/smartweb.c
index 2d42488..d82f1b7 100644
--- a/board/siemens/smartweb/smartweb.c
+++ b/board/siemens/smartweb/smartweb.c
@@ -90,7 +90,8 @@
pin_to_mask(AT91_PIN_PA17) |
pin_to_mask(AT91_PIN_PA25) |
pin_to_mask(AT91_PIN_PA26) |
- pin_to_mask(AT91_PIN_PA28),
+ pin_to_mask(AT91_PIN_PA28) |
+ pin_to_mask(AT91_PIN_PA29),
&pioa->pudr);
at91_phy_reset();
@@ -101,7 +102,8 @@
pin_to_mask(AT91_PIN_PA17) |
pin_to_mask(AT91_PIN_PA25) |
pin_to_mask(AT91_PIN_PA26) |
- pin_to_mask(AT91_PIN_PA28),
+ pin_to_mask(AT91_PIN_PA28) |
+ pin_to_mask(AT91_PIN_PA29),
&pioa->puer);
/* Initialize EMAC=MACB hardware */
@@ -141,13 +143,6 @@
int board_init(void)
{
- /* Adress of boot parameters */
- gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;
-
- smartweb_nand_hw_init();
-#ifdef CONFIG_MACB
- smartweb_macb_hw_init();
-#endif
/* power LED red */
at91_set_gpio_output(AT91_PIN_PC6, 0);
at91_set_gpio_output(AT91_PIN_PC7, 1);
@@ -163,6 +158,13 @@
at91_udc_probe(&board_udc_data);
#endif
+ /* Adress of boot parameters */
+ gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;
+
+ smartweb_nand_hw_init();
+#ifdef CONFIG_MACB
+ smartweb_macb_hw_init();
+#endif
return 0;
}
@@ -197,6 +199,7 @@
void spl_board_init(void)
{
+ /* power LED orange */
at91_set_gpio_output(AT91_PIN_PC6, 1);
at91_set_gpio_output(AT91_PIN_PC7, 1);
/* alarm LED orange */
@@ -212,8 +215,8 @@
/* check if both button are pressed */
if (at91_get_gpio_value(AT91_PIN_PA28) == 0 &&
- at91_get_gpio_value(AT91_PIN_PA29) == 0) {
- debug("Recovery button pressed\n");
+ at91_get_gpio_value(AT91_PIN_PA29) == 0) {
+ smartweb_nand_hw_init();
nand_init();
spl_nand_erase_one(0, 0);
}