kw_spi: support spi_claim/release_bus functions
These two function nows ensure that the MPP is configured correctly for
the SPI controller before any SPI access, and restore the initial
configuration when the access is over.
Since the used pins for the SPI controller can differ (2 possibilities
for each signal), the used pins are configured with CONFIG_SYS_KW_SPI_MPP.
Signed-off-by: Valentin Longchamp <valentin.longchamp@keymile.com>
cc: Holger Brunck <holger.brunck@keymile.com>
cc: Prafulla Wadaskar <prafulla@marvell.com>
diff --git a/arch/arm/include/asm/arch-kirkwood/spi.h b/arch/arm/include/asm/arch-kirkwood/spi.h
index 1d5043f..c79bed7 100644
--- a/arch/arm/include/asm/arch-kirkwood/spi.h
+++ b/arch/arm/include/asm/arch-kirkwood/spi.h
@@ -37,6 +37,17 @@
u32 irq_mask; /* 0x10614 */
};
+/* They are used to define CONFIG_SYS_KW_SPI_MPP
+ * each of the below #defines selects which mpp is
+ * configured for each SPI signal in spi_claim_bus
+ * bit 0: selects pin for MOSI (MPP1 if 0, MPP6 if 1)
+ * bit 1: selects pin for SCK (MPP2 if 0, MPP10 if 1)
+ * bit 2: selects pin for MISO (MPP3 if 0, MPP11 if 1)
+ */
+#define MOSI_MPP6 (1 << 0)
+#define SCK_MPP10 (1 << 1)
+#define MISO_MPP11 (1 << 2)
+
#define KWSPI_CLKPRESCL_MASK 0x1f
#define KWSPI_CSN_ACT 1 /* Activates serial memory interface */
#define KWSPI_SMEMRDY (1 << 1) /* SerMem Data xfer ready */