spl: kconfig: separate sysreset and firmware drivers from misc
This adds separate kconfig options for drivers/sysreset and
drivers/firmware.
Up to now, CONFIG_SPL_DRIVERS_MISC_SUPPORT added drivers/misc to SPL
build but also added drivers/firmware and drivers/sysreset at the same
time.
Since that is confusing, this patch uses CONFIG_SPL_SYSRESET for
drivers/sysreset and adds CONFIG_SPL_FIRMWARE for
drivers/firmware (and accordingly for the TPL options).
CONFIG_SPL_DRIVERS_MISC_SUPPORT stays for including drivers/misc into
the SPL build (and accordingly for TPL) since there are boards using
non-DM (non UCLASS_MISC) files from drivers/misc. Such boards don't
have CONFIG_SPL_MISC enabled, so cannot use this to include
drivers/misc into the SPL build.
Signed-off-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>
diff --git a/drivers/firmware/Kconfig b/drivers/firmware/Kconfig
index 7d8f161..873bc8c 100644
--- a/drivers/firmware/Kconfig
+++ b/drivers/firmware/Kconfig
@@ -1,9 +1,13 @@
config FIRMWARE
bool "Enable Firmware driver support"
+config SPL_FIRMWARE
+ bool "Enable Firmware driver support in SPL"
+ depends on FIRMWARE
+
config SPL_ARM_PSCI_FW
bool
- select FIRMWARE
+ select SPL_FIRMWARE
config ARM_PSCI_FW
bool
@@ -13,6 +17,7 @@
tristate "TI System Control Interface (TISCI) Message Protocol"
depends on K3_SEC_PROXY
select FIRMWARE
+ select SPL_FIRMWARE if SPL
help
TI System Control Interface (TISCI) Message Protocol is used to manage
compute systems such as ARM, DSP etc with the system controller in