diff --git a/board/solidrun/clearfog/clearfog.c b/board/solidrun/clearfog/clearfog.c
index 2dbd071..74a1b46 100644
--- a/board/solidrun/clearfog/clearfog.c
+++ b/board/solidrun/clearfog/clearfog.c
@@ -227,6 +227,74 @@
 	return 0;
 }
 
+#define TLC59XXX_REG_MODE1 0x00
+#define TLC59XXX_REG_MODE2 0x01
+#define TLC59XXX_REG_PWM(LED) (LED + 0x02)
+#define TLC59XXX_REG_GRPPWM 0x12
+#define TLC59XXX_REG_GRPFREQ 0x13
+#define TLC59XXX_REG_LEDOUT0 0x14
+#define TLC59XXX_REG_LEDOUT1 0x15
+#define TLC59XXX_REG_LEDOUT2 0x16
+#define TLC59XXX_REG_LEDOUT3 0x17
+#define TLC59XXX_CHIP_RESET_ADDR 0x6b
+#define TLC59XXX_RESET_BYTE_0 0xa5
+#define TLC59XXX_RESET_BYTE_1 0x5a
+#define CLA_LED_CHIP_ADDR 0x60
+#define CLA_LED_STATUS_RED 8
+#define CLA_LED_STATUS_GREEN 9
+#define CLA_LED_STATUS_BLUE 10
+
+struct cla_led_config {
+	u8 reg;
+	u8 val;
+};
+
+static struct cla_led_config led_reset_config[] = {
+	{ TLC59XXX_RESET_BYTE_0, TLC59XXX_RESET_BYTE_1 },
+};
+
+static struct cla_led_config led_config[] = {
+	{ TLC59XXX_REG_MODE1, 0x01 }, /* enable oscillator */
+	{ TLC59XXX_REG_MODE2, 0x20 }, /* DMBLINK */
+	{ TLC59XXX_REG_GRPPWM, 0x40 }, /* 25% duty cycle */
+	{ TLC59XXX_REG_GRPFREQ, 0x03 }, /* very fast blinking */
+	{ TLC59XXX_REG_PWM(CLA_LED_STATUS_RED), 0x80 }, /* 50% brightness */
+	{ TLC59XXX_REG_PWM(CLA_LED_STATUS_GREEN), 0x80 }, /* 50% brightness */
+	{ TLC59XXX_REG_PWM(CLA_LED_STATUS_BLUE), 0x80 }, /* 50% brightness */
+	{ TLC59XXX_REG_LEDOUT2, 0x3f }, /* LEDs #8, 9, 10: mode 0b11 -> group blinking */
+};
+
+int cla_setup_leds(void)
+{
+	struct udevice *bus, *dev;
+
+	if (uclass_get_device_by_seq(UCLASS_I2C, 1, &bus)) {
+		puts("Cannot find I2C bus for LEDs\n");
+		return 1;
+	}
+
+	if (i2c_get_chip(bus, TLC59XXX_CHIP_RESET_ADDR, 1, &dev)) {
+		puts("Cannot request I2C chip for SWRST\n");
+		return 1;
+	}
+	if (dm_i2c_write(dev, led_reset_config[0].reg, &led_reset_config[0].val, 1)) {
+		puts("LED reset failed\n");
+		return 1;
+	}
+
+	if (i2c_get_chip(bus, CLA_LED_CHIP_ADDR, 1, &dev)) {
+		puts("Cannot request I2C chip for LEDs\n");
+		return 1;
+	}
+	for (int i = 0; i < ARRAY_SIZE(led_config); i++) {
+		if (dm_i2c_write(dev, led_config[i].reg, &led_config[i].val, 1)) {
+			printf("LED config operation #%d failed\n", i);
+			return 1;
+		}
+	}
+	return 0;
+}
+
 int board_init(void)
 {
 	/* Address of boot parameters */
@@ -243,6 +311,8 @@
 	setbits_le32(MVEBU_GPIO0_BASE + 0x0, BIT(19));
 	mdelay(10);
 
+	cla_setup_leds();
+
 	return 0;
 }