add Xilinx_abort_fn to Xilinx_Spartan3_Slave_Serial_fns
Currently the hardware was left in an undefined state in case Spartan3
serial load failed. This patch adds Xilinx_abort_fn to give the board
a possibility to clean up in this case.
Signed-off-by: Wolfgang Wegner <w.wegner@astro-kom.de>
diff --git a/drivers/fpga/spartan3.c b/drivers/fpga/spartan3.c
index 7a89b56..1dd6f26 100644
--- a/drivers/fpga/spartan3.c
+++ b/drivers/fpga/spartan3.c
@@ -366,6 +366,8 @@
CONFIG_FPGA_DELAY ();
if (get_timer (ts) > CONFIG_SYS_FPGA_WAIT) { /* check the time */
puts ("** Timeout waiting for INIT to start.\n");
+ if (*fn->abort)
+ (*fn->abort) (cookie);
return FPGA_FAIL;
}
} while (!(*fn->init) (cookie));
@@ -380,6 +382,8 @@
CONFIG_FPGA_DELAY ();
if (get_timer (ts) > CONFIG_SYS_FPGA_WAIT) { /* check the time */
puts ("** Timeout waiting for INIT to clear.\n");
+ if (*fn->abort)
+ (*fn->abort) (cookie);
return FPGA_FAIL;
}
} while ((*fn->init) (cookie));
@@ -394,6 +398,8 @@
while DONE is low (inactive) */
if ((*fn->done) (cookie) == 0 && (*fn->init) (cookie)) {
puts ("** CRC error during FPGA load.\n");
+ if (*fn->abort)
+ (*fn->abort) (cookie);
return (FPGA_FAIL);
}
val = data [bytecount ++];
diff --git a/include/spartan3.h b/include/spartan3.h
index d5a589d..0f0b400 100644
--- a/include/spartan3.h
+++ b/include/spartan3.h
@@ -58,6 +58,7 @@
Xilinx_wr_fn wr;
Xilinx_post_fn post;
Xilinx_bwr_fn bwr; /* block write function */
+ Xilinx_abort_fn abort;
} Xilinx_Spartan3_Slave_Serial_fns;
/* Device Image Sizes