mx6sabresd: Fix error handling in board_mmc_init()
When an invalid USDHC port is passed we should return -EINVAL instead of 0.
Also, return the error immediately on fsl_esdhc_initialize() failure.
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
diff --git a/board/freescale/mx6sabresd/mx6sabresd.c b/board/freescale/mx6sabresd/mx6sabresd.c
index eda8497..44942ff 100644
--- a/board/freescale/mx6sabresd/mx6sabresd.c
+++ b/board/freescale/mx6sabresd/mx6sabresd.c
@@ -257,7 +257,7 @@
int board_mmc_init(bd_t *bis)
{
#ifndef CONFIG_SPL_BUILD
- s32 status = 0;
+ int ret;
int i;
/*
@@ -290,13 +290,15 @@
printf("Warning: you configured more USDHC controllers"
"(%d) then supported by the board (%d)\n",
i + 1, CONFIG_SYS_FSL_USDHC_NUM);
- return status;
+ return -EINVAL;
}
- status |= fsl_esdhc_initialize(bis, &usdhc_cfg[i]);
+ ret = fsl_esdhc_initialize(bis, &usdhc_cfg[i]);
+ if (ret)
+ return ret;
}
- return status;
+ return 0;
#else
unsigned reg = readl(BOOT_CFG) >> 11;
/*