am33xx: Re-enable SW levelling for DDR2
The recent changes for hw leveling on am33xx were not intended for
DDR2 boards, only DDR3. Update emif_sdram_type to take a sdram_config
value to check against. This lets us pass in the value we would use to
configure, when we have not yet configured the board yet. In other cases
update the call to be as functional as before and check an already
programmed value in.
Tested-by: Yan Liu <yan-liu@ti.com>
Signed-off-by: Tom Rini <trini@ti.com>
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
diff --git a/arch/arm/cpu/armv7/omap-common/clocks-common.c b/arch/arm/cpu/armv7/omap-common/clocks-common.c
index fa04bbe..c94a807 100644
--- a/arch/arm/cpu/armv7/omap-common/clocks-common.c
+++ b/arch/arm/cpu/armv7/omap-common/clocks-common.c
@@ -372,6 +372,7 @@
{
u32 temp;
const struct dpll_params *params;
+ struct emif_reg_struct *emif = (struct emif_reg_struct *)EMIF1_BASE;
debug("setup_dplls\n");
@@ -382,7 +383,8 @@
* Core DPLL will be locked after setting up EMIF
* using the FREQ_UPDATE method(freq_update_core())
*/
- if (emif_sdram_type() == EMIF_SDRAM_TYPE_LPDDR2)
+ if (emif_sdram_type(readl(&emif->emif_sdram_config)) ==
+ EMIF_SDRAM_TYPE_LPDDR2)
do_setup_dpll((*prcm)->cm_clkmode_dpll_core, params,
DPLL_NO_LOCK, "core");
else