Use separate options for TPL support
At present TPL uses the same options as SPL support. In a few cases the board
config enables or disables the SPL options depending on whether
CONFIG_TPL_BUILD is defined.
With the move to Kconfig, options are determined for the whole build and
(without a hack like an #undef in a header file) cannot be controlled in this
way.
Create new TPL options for these and update users. This will allow Kconfig
conversion to proceed for these boards.
Signed-off-by: Simon Glass <sjg@chromium.org>
diff --git a/drivers/Makefile b/drivers/Makefile
index 7861d34..ca982731 100644
--- a/drivers/Makefile
+++ b/drivers/Makefile
@@ -40,8 +40,22 @@
obj-$(CONFIG_SPL_SATA_SUPPORT) += block/
obj-$(CONFIG_SPL_USB_HOST_SUPPORT) += block/
obj-$(CONFIG_SPL_MMC_SUPPORT) += block/
+endif
-else
+ifdef CONFIG_TPL_BUILD
+
+obj-$(CONFIG_TPL_I2C_SUPPORT) += i2c/
+obj-$(CONFIG_TPL_DRIVERS_MISC_SUPPORT) += misc/ sysreset/
+obj-$(CONFIG_TPL_MMC_SUPPORT) += mmc/
+obj-$(CONFIG_TPL_MPC8XXX_INIT_DDR_SUPPORT) += ddr/fsl/
+obj-$(CONFIG_TPL_NAND_SUPPORT) += mtd/nand/
+obj-$(CONFIG_TPL_SERIAL_SUPPORT) += serial/
+obj-$(CONFIG_TPL_SPI_FLASH_SUPPORT) += mtd/spi/
+obj-$(CONFIG_TPL_SPI_SUPPORT) += spi/
+
+endif
+
+ifeq ($(CONFIG_SPL_BUILD)$(CONFIG_TPL_BUILD),)
obj-y += adc/
obj-$(CONFIG_DM_DEMO) += demo/