mx35: add DT support to flea3 board
Signed-off-by: Heiko Schocher <hs@denx.de>
diff --git a/board/CarMediaLab/flea3/flea3.c b/board/CarMediaLab/flea3/flea3.c
index 2463077..be42863 100644
--- a/board/CarMediaLab/flea3/flea3.c
+++ b/board/CarMediaLab/flea3/flea3.c
@@ -19,6 +19,9 @@
#include <asm/gpio.h>
#include <asm/arch/sys_proto.h>
#include <netdev.h>
+#include <fdt_support.h>
+#include <mtd_node.h>
+#include <jffs2/load_kernel.h>
#ifndef CONFIG_BOARD_EARLY_INIT_F
#error "CONFIG_BOARD_EARLY_INIT_F must be set for this board"
@@ -276,3 +279,24 @@
return (get_cpu_rev() & ~(0xF << 8)) | (rev & 0xF) << 8;
}
+
+/*
+ * called prior to booting kernel or by 'fdt boardsetup' command
+ *
+ */
+int ft_board_setup(void *blob, bd_t *bd)
+{
+ struct node_info nodes[] = {
+ { "physmap-flash.0", MTD_DEV_TYPE_NOR, }, /* NOR flash */
+ { "mxc_nand", MTD_DEV_TYPE_NAND, }, /* NAND flash */
+ };
+
+ if (getenv("fdt_noauto")) {
+ puts(" Skiping ft_board_setup (fdt_noauto defined)\n");
+ return 0;
+ }
+
+ fdt_fixup_mtdparts(blob, nodes, ARRAY_SIZE(nodes));
+
+ return 0;
+}