mtd: vf610_nfc: remove read on SEQIN
Since we do not support sub-page writes anyway, reading the page
back to the controller on SEQIN command is not required. Remove
the page read on SEQIN.
However, the column/page values relevant to the SEQIN command, hence
set the column/row address on SEQIN command.
Signed-off-by: Stefan Agner <stefan@agner.ch>
diff --git a/drivers/mtd/nand/vf610_nfc.c b/drivers/mtd/nand/vf610_nfc.c
index fa0bb9d..66b335d 100644
--- a/drivers/mtd/nand/vf610_nfc.c
+++ b/drivers/mtd/nand/vf610_nfc.c
@@ -345,24 +345,26 @@
nfc->alt_buf = 0;
switch (command) {
+ case NAND_CMD_SEQIN:
+ /* Use valid column/page from preread... */
+ vf610_nfc_addr_cycle(mtd, column, page);
+ /*
+ * SEQIN => data => PAGEPROG sequence is done by the controller
+ * hence we do not need to issue the command here...
+ */
+ return;
case NAND_CMD_PAGEPROG:
vf610_nfc_transfer_size(nfc->regs, nfc->page_sz);
vf610_nfc_send_commands(nfc->regs, NAND_CMD_SEQIN,
command, PROGRAM_PAGE_CMD_CODE);
- vf610_nfc_addr_cycle(mtd, column, page);
break;
case NAND_CMD_RESET:
vf610_nfc_transfer_size(nfc->regs, 0);
vf610_nfc_send_command(nfc->regs, command, RESET_CMD_CODE);
break;
- /*
- * NFC does not support sub-page reads and writes,
- * so emulate them using full page transfers.
- */
case NAND_CMD_READOOB:
nfc->spareonly = 1;
- case NAND_CMD_SEQIN: /* Pre-read for partial writes. */
case NAND_CMD_READ0:
column = 0;
vf610_nfc_transfer_size(nfc->regs, nfc->page_sz);